Advertisement
Quick Links
MYS-7Z010_20-V2
Development Kit
Quick Start Guide
Software and Documents can be accessed at：
✭
http://d.myirtech.com/Z-turn-board
✭ Technical Support：
Please feel free to contact us if you have any technical
problems:
• Email：support@myirtech.com
• Telephone：(+86) 0755 22984836
• Website： www.myirtech.com
Advertisement
Related Manuals for MYiR MYS-7Z010 20-V2
Summary of Contents for MYiR MYS-7Z010 20-V2
- Page 1 MYS-7Z010_20-V2 Development Kit Quick Start Guide Software and Documents can be accessed at： ✭ Technical Support： ✭ Please feel free to contact us if you have any technical problems: http://d.myirtech.com/Z-turn-board • Email：support@myirtech.com • Telephone：(+86) 0755 22984836 • Website： www.myirtech.com...
- Page 2 1.Hardware Interface & Points of Attentions Top View of MYS-7Z010_20-V2 Development Kit Points of Attentions： 1.The board has been burned into the factory image program in the SD card of the board. You only need to follow the following steps to start the board (please make sure that the board is set to start on the SD card). 2.To avoid any damage on the board , please make sure using the power adapter(5V DC) coming with the board in the box.
- Page 3 Step1：Configure the boot options Insert the jumper cap and set the boot mode to SD card boot mode. Boot Mode ARM+FPGA Boot from SD disconnection close Boot from QSPI close close...
- Page 4 2. 使用5V/2A电源，以避免损坏板注意事项： Step2：Ensure that the SD card is in the Step3：Connect the HDMI 1.板卡出厂时已经烧入了出厂镜像程序在核心板的eMMC或NAND中，您只需要按下面步骤就可以开机启动（请 card slot 确保板卡设置在eMMC启动或NAND启动）。 Connect the HDMI monitor with the HDMI cable.Please skip this if you don't need a HDMI 2. 使用5V/2A电源，以避免损坏板卡。卡。 display. ： 1.板卡出厂时已经烧入了出厂镜像程序在核心板的eMMC或NAND中，您只需要按下面步骤就可以开机启动确保 板卡设置在eMMC启动或NAND启动）。 Step4：Connect the power adapter Connect 5V power adapter to the power-in connector(J10) Connect 5V power adapter to the power- Connect 5V power adapter to the power-in connector(J10)
- Page 5 Step 5: Connect the debugging Step6：Set Debug Serial Port and start to serial cable debug Connect a PC to a board connector using Open the serial terminal software on host PC and set the parameters as below: a USB-mini serial cable (J6) Note: The MINI USB port has two, to Band Data bits...
Need help?
Do you have a question about the MYS-7Z010 20-V2 and is the answer not in the manual?
Questions and answers