7. Connecting Cords
K
• Connect the Controller
with the AC Adapter
motor as shown.
M
• Insert the Power Plug
into the AC Adapter.
NOTE: Do not connect to power supply before the desk
is fully assembled.
K
L
M
8. Attaching the Controller, AC
Adapter and Cable Tie
• Attach the Controller to the desktop using 2 ST3.5x13
Screws
S-M
.
• Attach the AC Adapter to the desktop using 2 ST4.2x16
Screws
S-N
.
S-Q
• Attach the Cable Tie
to the desktop using the
ST3.5x13 Screw
S-M
, and then organize the cables for a
clean look.
S-M
S-M
S-Q
9. Assemble the Shelf
L
R
and
・Assemble the Shelf Brackets
Q
・Attach Shelf Board
to the Bracket using 2 ST4.2x35 Screws
V
・Attach 4 Leveling Feet
to the bottom of the shelf.
・Attach the 2 Connecting Components
・Attach the Crossbar
S
the the Shelf using 2 Washers
U
・ Attach the Shelf Frame to the Shelf Board
S-F
Screws
and 7 ST4.2x35 Screws
S-F
Drill
S-N
ELECTRIC SIT-STAND DESK
WITH STORAGE SHELF
T
S-B
/
using 12 M6x40 Screws
.
S-J
.
U
to the Crossbar
S
using 2 M5x10 Screws
S-I
S-O
and 2 M5x40 Screws
T
R
S-B
Q
S-I
S-O
S
S-H
O
using 8 M6x12
S-J
as shown.
S-J
Instruction Manual
Item No.: 3015652 (3027999)
SP-SSD-NW01
10. Assemble the Shelf and Shelf Board
・Insert the Shelf to the desk frame as shown. Tighten the two per-installed
S-G
M6x8 screws
and attach another 2 M6x8 screws
・Attach the Shelf Board
CAUTION: After attaching the shelf to the desk frame, other side of the shelf should
S-H
.
be padded with foam or other items to keep the shelf level.
.
V
S-C
F
S-J
S-C
11. Adjusting the Desk
• There are two adjustable foot pads under each foot and four leveling
feet under the shelf. If the floor isn't even, simply turn the pad or
leveling foot to adjust the level to make the desk stable.
TIP: Use a spirit level to check the desk is level (not included).
• Connect the desk to power. Keep holding the press on the controller
to adjust the desk to desired height.
CAUTION: To prevent injury, at least two people are required when turning
the desk over.
Bubble Level
O
S-G
to the column.
P
S-J
to the Shelf Frame using 4 ST4.2x35 Screws
S-J
P
Foam or other
items to level
S-G
the shelf
Attaching the Feet
F
• Attach the Foot
to the Lifting Column
S-C
using 6 M6x30 Screws
.
G
• Attach the Foot
to the Lifting Column
using 4 M6x30 Screws
S-C
.
G
Foam or other
items to level
the shelf
.
Need help?
Do you have a question about the SP-SSD-NW01 and is the answer not in the manual?
Questions and answers