Care And Cleaning; Plasma Panel's Protection Function; Image Burn-In And After-Image Lag - RCA P42WED33 User Manual

Rca p42wed33: users guide
Hide thumbs Also See for P42WED33:
Table of Contents

Advertisement

REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE
CONSUMER. TTE TECHNOLOGY, INC. SHALL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL
DAMAGES RESULTING FROM THE USE OF THIS PRODUCT OR ARISING OUT OF ANY BREACH OF ANY
EXPRESS OR IMPLIED WARRANTY ON THIS PRODUCT. THIS DISCLAIMER OF WARRANTIES AND LIMITED
WARRANTY ARE GOVERNED BY THE LAWS OF THE STATE OF INDIANA. EXCEPT TO THE EXTENT
PROHIBITED BY APPLICABLE LAW, ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR
A PARTICULAR PURPOSE ON THIS PRODUCT IS LIMITED TO THE APPLICABLE WARRANTY PERIOD SET
FORTH ABOVE.
How State Law relates to warranty:
Some states do not allow the exclusion nor limitation of incidental or consequential damages, or limitations on how
long an implied warranty lasts, so the above limitations or exclusions may not apply to you.
This warranty gives you specifi c legal rights, and you also may have other rights that vary from state to state.
If you purchased your unit outside the United States:
This warranty does not apply. Contact your dealer for warranty information.
Service calls which do not involve defective materials or workmanship are not covered by this warranty.
Costs of such service calls are the sole responsibility of the purchaser.

Care and Cleaning

CAUTION: Turn OFF your TV before cleaning.
You can clean the TV as required, using a soft lint-free cloth. Be sure to occasionally dust the ventilation slots in the
cabinet to help assure adequate ventilation.
IMPORTANT: Never use strong cleaning agents, such as ammonia-based cleaners, or abrasive powder. These
types of cleaners will damage the TV.
The TV's screen may be cleaned with a soft, lint-free cloth as well. Take care not to scratch or mar the screen.
If necessary, you may use a cloth dampened with warm water. While cleaning do not spray liquid directly on the
screen, or allow liquid to run down the screen and inside the TV. Also, never place drinks or vases with water on top of
the TV. This could increase the risk of fi re or shock hazard or damage to the TV.

Plasma Panel's Protection Function

The brightness of this monitor will dim slightly when an image with little movement such as a photograph or computer
image is continuously displayed. This is caused by the plasma panel's protection function which detects images with
slight movement and automatically adjusts brightness to protect the monitor, and is not a malfunction.
The screen-saver function begins operating when the monitor detects no or little screen movement for a period of about
three minutes.

Image Burn-in and After-image Lag

Displaying the same images such as still images for a long time may cause after-image lagging. This may occur in the
following two cases:
1. After-image (lag image) due to burning:
Avoid displaying the same image on the Plasma Monitor continuously over a long period of time. If the same image is
displayed continuously for several hours, or for shorter periods of time over several days, a permanent after-image may
remain on the screen due to burning of the fl uorescent materials. Such images may become less noticeable if moving
images are later displayed, but they will not disappear completely. Note this damage is not covered by your warranty.
2. After-image lagging due to remaining electrical load:
When image patterns with very high peak luminance are displayed for more than 1 minute, after-image lagging may
occur due to the remaining electric load. The after-images remaining on the screen will disappear when moving images
are displayed. The time for the after-images to disappear depends on the luminance of the still images and the time they
had been displayed.
Chapter 5
Other Information
49

Advertisement

Table of Contents
loading

This manual is also suitable for:

P42whd500P42whd33

Table of Contents