Pogo TSR-500 User Manual page 7

TSR-500 User Manual
Note : If you are replacing old batteries, TSR/500 will retain its setup and program-
ming indefinitely, even without batteries.
Note : After replacing the batteries, the Touch Pad Calibration Screen will appear.
To ensure accurate LCD touch entry, you will need to calibrate the touch pad.
Using a stylus or pencil, touch the center of all three targets. This enables the Touch
Pad set-up.
Note : Do not mix old and new batteries. If your TSR/500 is not to be used for a long
period of time, remove the old batteries to prevent leakage and internal damage.
Reset of Battery
Under normal circumstances, you will never have to reset the TSR/500. However, on
rare occasions, if the TSR/500's touch screen freezes or if you notice unusual behav-
ior, you need to perform a reset to get the TSR/500 running again. All customized
commands and devices are retained.
1. Remove the battery cover on the back of TSR/500 by pressing and sliding.
2. Use an unfolded paperclip to carefully press the Reset button
3. Replace the battery cover back on.
4. After performing the reset, you will need to calibrate the touch pad to ensure
accurate LCD touch entry.
7