Pioneer PDP-5010FD Operating Instructions Manual page 23

Preparation
PDP-5010FD with the speaker installed
(with the Pioneer table top stand)
Speaker mounting
screw (M5 x 10 mm)
Speaker mounting fitting
(side)
Note
• Before installing the speaker, make sure that the Pioneer
table top stand is attached to the plasma display.
1 Attach the speaker mounting fittings to the rear
of the plasma display.
• Attach the fittings for right and left sides to the bottom
right and left on the rear panel of the plasma display using
the supplied screws.
Speaker mounting screw
(M5 x 10 mm)
Speaker mounting fitting for side
(It shows the attachment of the fitting on
the left side. It is attached on the right
side by the same procedure.)
Speaker mounting
screw (M5 x 10 mm)
4 5
Speaker cable
Bead band
➀ Tighten the screw in
the upper screw hole
first.
➁ Then, tighten the
screw in the screw
hole right under the
upper hole.
Speaker
Speaker mounting fitting
(center)
• Attach the fitting for center to the lower center on the rear
panel of the plasma display using the two supplied screws.
➁ Then, tighten the screw
in the oval-shaped screw
hole.
Speaker mounting screw
(M5 x 10 mm)
Speaker mounting fitting for center
Speaker mounting
screw (M5 x 10 mm)
Speaker mounting fitting
(side)
➀ Tighten the screw
in the round-
shaped hole first.
05
23
En