Pioneer PDP-5010FD Operating Instructions Manual page 19

Preparation
Installation
• The speaker is wide, and may become unstable when installed
by a one person alone. This may result in injury or product
damage. Therefore, at least two people must assemble and
install it.
PDP-6010FD with the speaker installed
(with the Pioneer table top stand)
Speaker mounting
screw (M5 x 10 mm)
Speaker mounting fitting
(right side)
Note
• Before attaching the speaker, please attach the table top stand
to the plasma display unit.
1 Attach the speaker mounting fittings to the rear
of the plasma display.
• Attach the fittings for right and left sides to the bottom
right and left on the rear panel of the plasma display using
the supplied screws.
• Finger tighten the two screws in the order
1
2
Speaker mounting
screw (M5 x 10 mm)
Speaker mounting fitting for the left side
(the fitting method is the same as the
fitting for the right side)
Speaker mounting
screw (M5 x 10 mm)
Speaker
Speaker cable
followed by
Label "L" is affixed to the
left side fitting. (Similarly,
label "R" is affixed to the
right side fitting.)
• When installing the speaker, do not use any screws other than
those supplied, otherwise the speaker may come off from the
main unit and fall over.
• When installing the speaker, tighten the screws firmly.
Speaker mounting fitting
(center)
• Attach the center fitting to the lower center on the rear
panel of the plasma display using the two supplied screws.
• Tighten the two screws in the order
drawing.
• When fitting the screws, place screws
the holes in the center fitting.
.
2
1
Speaker mounting screw
(M5 x 10 mm)
Note
• See page 22 for speaker mounting procedures when using the
hung on wall unit.
Speaker mounting
screw (M5 x 10 mm)
Speaker mounting fitting
(left side)
, as shown in the
and through
Speaker mounting fitting for
center
05
19
En