Pioneer Elite VSX-55TXi Operating Instructions Manual page 66

Remote Control of Other Components
Memo:
• If FULL appears in step 5 it means that
there isn't enough capacity to learn this
command. If you want to clear other
buttons to make room for this one follow
the procedure on page 85.
If there isn't enough capacity, an incorrect
•
signal has been sent or, in some cases, the
command from another remote control
simply cannot be learned, NG (no good)
will appear in the display in step 5.
In some NG cases the remotes just need to
•
be moved closer together or farther apart.
66
Buttons that are able
to learn new
commands
5 While LEARN continues to flash, point
the two remote controls toward each
other. Press the button on the other
remote control corresponding to the
operation you want to program.
After the process is complete and the command has
been learned, OK will appear in the remote control dis-
play. If NG (no good) appears, it means that for some rea-
son the command was not learned. In this case, repeat
steps 4 and 5.
CONTINUE? appears in the remote's display. If SELECT
KEY is flashing go back to step 4.
6 If you want to program in more
commands use the  buttons to
select YES. Press ENTER.
Repeat steps 4 and 5 to teach the remote control of the
VSX-55TXi all the commands from the other remote con-
trol.
7 If you want to program in commands
for another MULTI CONTROL button
use the  buttons to select NO.
Press ENTER.
8 Repeat the process from step 2 for all
of your components.
Start again to program other components in this manner.
9 When you're done use the 
buttons to select EXIT.
You will return to the REMOTE SETUP menu.
10Use  to select EXIT and press
ENTER.