Easy Setup Guide Part 2; Auto Surround Sound Setup - Pioneer Elite VSX-55TXi Operating Instructions Manual

Easy Setup Guide Part 2

1 Auto Surround Sound Setup

If setting up your surround sound speakers seems like it's going to be an involved task you only need to use this
quick, automatic method, known as the MCACC system, to achieve good surround sound. You'll need to hook up the
microphone so that the receiver can hear and judge the distance, size, sound character and sound pressure level of
the speakers and thus know what settings to make.
First turn the volume down, then plug the microphone into the SETUP MIC jack on the front panel of the receiver
and put the microphone into its stand.
Follow the step-by-step guide to setting up your surround sound below. This will customize the surround sound for
your listening environment. If you want to personalize your surround sound setups by making the settings manually
go to "Setting up for Surround Sound" (starting on page 38) and "Expert Setup" (starting on page 96). Make sure all
the components you need, especially speakers, have been properly connected before you do the steps described
here.
1
microphone
Center Speaker
Subwoofer
Front
Speaker
(L)
Listening
Position
Surround Speaker (L)
7
1
2
microphone
stand
Front Speaker (R)
3
Surround
Speaker
(R)
Surround
Back
Speaker 4
(R)
5
Surround Back
Speaker (L)
6
7
Easy Setup Guide Part 2
Hook up the microphone to the
SETUP MIC jack on the Front Panel.
Place the microphone at your normal
listening position.
Use a table, chair or something else to put the micro-
phone at the same height as you usually listen to your
system from.
If you have a tripod you can affix the mic stand to it.
Switch on the receiver and your TV.
Make sure your TV is set to this receiver as you will
use the on-screen displays (OSDs) on your TV to fol-
low these instructions.
If you have a subwoofer turn it on.
Press the RECEIVER button on the
remote control.
Press the SYSTEM SETUP button and
use the on-screen display (OSD) that
appears on your TV.
The arrow should be pointing at
SURROUND SETUP, press ENTER.
13