Pioneer SE-DIR800C Operating Instructions Manual page 21

Operation
Note
! To listen to dual audio (main/sub) sound
sources, connect to the LINE IN jack, and
then select the channel(s) you want to
listen to on the source.
5 Start playback of your source
component.
6 Use the DOLBY HEADPHONE and
DOLBY PRO LOGIC II buttons to select the
output mode (surround sound effect).
Indicator
Press repeatedly to change playback modes
(see the table below).
Output mode (Surround effect)
Multi-channel source DH mode
Dolby Headphone playback for multichannel Dolby Digital or
DTS sources.
This setting recreates 5.1 channel (front left/right, center,
surround left/right and subwoofer) playback through
headphones.
Dolby Pro Logic II DH mode
Dolby Headphone playback, for stereo sources, with Dolby Pro
Logic II decoding for surround sound.
This setting creates 5.1 channel (front left/right, center,
surround left/right and subwoofer) playback from stereo
sources through headphones.
Stereo source DH mode
Dolby Headphone playback, for stereo sources, without Dolby
Pro Logic II decoding.
This setting recreates stereo playback from speakers in front of
you through headphones.
Dolby Headphone mode OFF
Regular headphone playback.
03
21
En