Philips HTS3051 User Manual page 50

Enable(Easy)
"Advanced
home A"Settings" A
Setup"
Network settings are set to the following settings initially.
(In most cases, you can connect to the Internet without
making any changes to the default settings.)
- IP Address Setting
- DNS Setting
- Proxy Setting
- Connection Speed
- BD-Live Setting
If you want to set the network settings back to the default
settings as above (except "BD-Live Setting"), follow the
procedure below.
1) Follow steps 1) to 4) in "Connection Test" on page
49.
2) Use [K / L] to select "Enable(Easy)", then press [OK].
• The unit will start the connection test automatically
and the test result will appear right after the test
finishes.
• After the connection test finishes, press [OK] to go to
network status confirmation screen.
3) Press [OK] to activate the network settings and set
the network connection automatically. [
to go back to the home menu.
Note
• The setting of "BD-Live Setting" will not be set back
to the default, even if you follow the procedure.
Enable(Custom)
"Advanced
home A"Settings" A
Setup"
In following cases, select "Enable(Custom)" to set each
setting as necessary.
- When connection test failed with the setting of
"Enable(Easy)".
- When instructed by your Internet service provider to
make specific settings in accordance with your
network environment.
IP Address Setting / DNS Setting
1) Follow steps 1) to 4) in "Connection Test" on page
49.
2) Use [K / L] to select "Enable(Custom)", then press
[OK].
3) Use [K / L] to select "IP Address Setting", then press
[OK].
4) Use [K / L] to select the desired setting, then press
[OK].
"Auto(DHCP)"
"Manual"
50 EN
SETUPS
"Network "Enable
A"Others" A A
Connection" (Easy)"
Auto(DHCP)
Auto(DHCP)
Do Not Use
Auto
Allow
(home)]
"Network "Enable
A "Others" A A
Connection" (Custom)"
: If your router has DHCP server
function, select "Auto(DHCP)".
: If your router does not have DHCP
server function, select "Manual".
If you select "Manual", follow the following
instruction to set the IP address and DNS.
4-a) IP address setting screen will appear. Enter IP
address, subnet mask and default gateway with
cursor buttons and number buttons.
IP Address Setting
IP Address
Subnet Mask
Default Gateway
Clear
• Enter the IP address number after checking the
specifications of your router.
• If the IP address is unknown, check the IP
address of other devices. (e.g. PC connected via
LAN cable) and assign a different number from
those of other devices.
After you enter all correctly, press [OK] to go to the
DNS setting screen.
4-b) DNS setting screen will appear. Enter primary DNS
and secondary DNS with cursor buttons and
number buttons.
DNS Setting
Primary DNS
Secondary DNS
Clear
• Enter the DNS addresses provided by your
Internet provider.
• If the DNS address is unknown, check the DNS
address of other devices (e.g. PC connected via
LAN cable) and assign the same DNS address.
4-c) After you enter all correctly, press [OK].
• Confirmation message will appear. Select "Yes"
to complete the settings.
IP Address
Subnet Mask
Default Gateway
Primary DNS
Secondary DNS
5) Press [BACK U] to go back to the previous screen,
or press [ (home)] to go back to the home menu.
OK
OK
xxx.xxx.xxx.xxx
xxx.xxx.xxx.xxx
xxx.xxx.xxx.xxx
xxx.xxx.xxx.xxx
xxx.xxx.xxx.xxx
Is Setting OK?
Yes
No