Setting The Image Finishing Tone; Setting Custom Image - Pentax K-r Operating Manual

Setting the Image Finishing Tone

Setting Custom Image

You can set the image finishing tone before shooting when the capture
mode is set to e (Program), K (Sensitivity Priority), b (Shutter Priority),
c (Aperture Priority) or a (Manual).
Select from the following nine modes for the image finishing tone: Bright
(default setting), Natural, Portrait, Landscape, Vibrant, Muted, Bleach
Bypass, Reversal Film and Monochrome. You can adjust the following
parameters for Image Tone.
Parameter
Sets the color saturation.
Saturation
• Not available when [Reversal Film] or
[Monochrome] is selected.
Sets the color.
• Not available when [Bleach Bypass],
Hue
[Reversal Film] or [Monochrome] is
selected.
Changes the brightness of the image.
High/Low Key
• Not available when [Reversal Film] is
Adj
selected.
Sets the image contrast.
Contrast
• Not available when [Reversal Film] is
selected.
Sets the sharpness of the image outlines.
You can switch to [Fine Sharpness] which
Sharpness makes image outlines even thinner and
sharper. Not available when the capture
mode is set to C (Movie).
Changes the contrast to appear as if a B&W
color filter was used. Set the filter color.
Filter Effect
• Available only when [Monochrome] is
selected.
Sets a color tone for [Bleach Bypass].
Sets the level for cold tone adjustment
(- direction) and warm tone adjustment
Toning
(+ direction) for [Monochrome].
• Available only when [Bleach Bypass] or
[Monochrome] is selected.
Settings Setting Values
–4 to +4
–4 to +4
–4 to +4
–4 to +4
–4 to +4
None/Green/Yellow/
Orange/Red/
Magenta/Blue/Cyan/
Infrared Filter
Bleach Bypass: Off/
Green/Yellow/
Orange/Red/
Magenta/Purple/Blue/
Cyan
Monochrome: –4 to
+4
213
6