Gyroscope Calibration - DroneTech TECHDRONE Online Manual

Flight code
1. Insert the drone's battery into the battery compartment the right way round, then place the drone on level ground. Press the
power button twice and hold the power button for 3 seconds to turn on the unit.
2. Turn on the remote control:
• If the remote control and the device are connected, no further pairing with other devices or remote
controls is required.
• When the remote control is paired with the drone, make sure that no other remote control and the
drone are connected at the same time, otherwise there will be a risk of signal error.

Gyroscope calibration

After successful coding, place the drone on level ground. Press the left stick towards the lower right corner at 45° as
shown below, and push the right stick towards the lower left corner at 45°. The front and rear indicators will flash
rapidly and the gyro will enter calibration. When the status indicator changes from flashing to steady, calibration is
complete.
• When calibrating the gyro, be sure to place the unit on a flat surface, otherwise it will affect
flight.
• The gyro is calibrated at the factory, and the user does not need to perform the calibration.
This is only done when the initialization cannot be exited.
power switch
5
5
6
.