Advertisement
Quick Links
CONTACT
1-844-282-4401
cubii.com/help
support@mycubii.com
® Trademark of Fitness Cubed Inc. Registered in the US.
Using Your Cubii Go
Follow the guidelines below to enhance your experience.
DISPLAY MONITOR
1.
Press the button under the
display to wake it.
Top Line:
2.
Stride count.
Bottom Line:
3.
Cycles between
Time, Calories, Distance, and
RPM (Revolutions Per Minute).
4.
Scan Mode:
The display will
automatically cycle through
these metrics.
5.
Reset The Strides To Zero:
Hold
button down for 3 seconds.
6.
To Change The Units Between
Miles And Kilometers:
Hold
button down for 5 seconds.
ADJUSTING THE
RESISTANCE
Cubii Go comes with 8 resistance
levels. Turn the knob clockwise
to increase the resistance. The
higher the number, the higher the
resistance. We recommend you
begin at Level 1 and increase the
intensity gradually over time.
Display
Button
Please Note:
Cubii Go is only to be used while sitting. Do not stand on the elliptical.
Not for use directly on shag carpet. Place a mat underneath the elliptical. Consult your
physician before starting this or any exercise program.
v14.2
TRANSPORTING AND POSITIONING
To extend the handle, hold down the handle release button, then pull out the
handle. Hold down the button again to fully retract the handle. The Cubii Go
can be used with the handle extended or retracted. The unit can also be lifted
up to carry like a briefcase or rolled on the floor like a roller bag.
USING THE CHAIR WHEEL CUP
If you're using Cubii Go while sitting in a chair with wheels or castors, follow
the steps below:
1.
Extend the handle by at least 1
position to expose the wheel cup.
2.
Roll the wheel of your chair into
the wheel cup.
Resistance
Knob
Quick Star t Guide
Handle
Release
Button
Wheel
Cup
Advertisement
Related Manuals for Cubii Go
Summary of Contents for Cubii Go
- Page 1 Reset The Strides To Zero: Hold USING THE CHAIR WHEEL CUP button down for 3 seconds. If you’re using Cubii Go while sitting in a chair with wheels or castors, follow To Change The Units Between the steps below: Miles And Kilometers:...
- Page 2 Lower the unit onto the crossbar so that the holes line up with the screws. Tighten screws with the included wrench, taking care not to scratch your Cubii Go. Find detailed product manual, assembly demo, and...
Need help?
Do you have a question about the Go and is the answer not in the manual?
Questions and answers
Why do my feet go to sleep while using this?
The Cubii Go is designed to be used only while sitting, and improper use may cause discomfort. If feet go to sleep while using it, it could be due to poor circulation from sitting too long, incorrect posture, or placing too much pressure on certain parts of the legs or feet. Ensuring proper seating position and taking breaks may help reduce this issue.
This answer is automatically generated