Clas Ohlson YH-MS029A-4 Manual

Compound Mitre Saw Stand
Art.no 41-9006-1 Model YH-MS029A-4
Please read the entire instruction manual before using the product and then save
it for future reference. We reserve the right for any errors in text or images and any
necessary changes made to technical data. In the event of technical problems or
other queries, please contact our Customer Services.
Safety
• Make sure that you have read and understood the instruction manual of the saw
that you intend to attach to the stand.
• The saw stand must only be used as described in this instruction manual.
• Keep your workplace tidy. Cluttered work areas cause accidents.
• Keep any bystanders, especially children, at a safe distance from the work area.
• Never overreach, stand steady and balanced at all times.
• Make sure that all of the legs are extended and locked by the ball catches and
that the rollers are at the correct height and locked.
• The stand must only be placed on a firm, flat surface.
• The stand must not be changed or modified in any way.
• Never stand on the saw stand or overload it in any way.
Product description
8
3
2
4 5 6 7
1
1. Roller height adjustment locking knob
2. Roller
3. Length adjustment locking knob
4. Stand
5. Mounting bracket
6. Coach bolt
7. Adaptor plates
8. Adaptor plate screws
Assembly
1. Turn the saw stand upside down, push in the ball catches and extend the legs.
Make sure that the ball catches click into place to lock the legs in the extended
position. Note: Be careful not to pinch your fingers when folding the legs in and out.
2. Stand the stand on its legs and mount the rollers
with the locking knobs and length adjustment
locking knobs.
3. Test fastening the mounting brackets onto the stand and check that they lock
on properly.
Press the back down
1 2
Hook the front first
4. Note: If the clamping handles do not lock the mounting brackets to the stand
properly they need to be adjusted. Undo the lock nut on the underside of
the mounting bracket and turn the adjuster screw clockwise to make the clamping
handles clamp the rails tighter. Tighten the lock nut again when you are happy
with the adjustment.
5. Check the number of fastening points on you saw. If your saw has four
symmetrical fastening points, read points 9, 10 and 11. If your saw only has three
fastening points or asymmetrical fastening points, you will need to use the adaptor
plates (7). Read points 6, 7 and 8. The included coach bolts are universal and may
need to be shortened slightly depending on which mitre saw is to be attached. If
the bolts stick up too much, they may obstruct the mitre saw turntable.
6. Remove the mounting brackets from the stand and attach the adaptor plates
according to the picture. Insert the coach bolts up through the slots in the adaptor
plates from underneath, pass a washer over the end of each bolt and then fasten
each bolt with a nut.
7. Mount the saw onto the adaptor plates.
8. Mount the saw and mounting bracket assembly onto the saw stand.
9. Remove the mounting brackets from
the stand and insert the coach bolts
up through the slots in the mounting
brackets from underneath, pass a
washer over the end of each bolt and
then fasten each bolt with a nut.
10. Attach the mounting bracket to the saw.
3
11. Mount the saw and mounting bracket
assembly onto the saw stand.
Turn the
handle down to
lock the bracket
in place
Responsible disposal
The product should be disposed of in accordance with local regulations.
If you are unsure how to proceed, contact your local council.
Specifications
Height to mounting brackets
Collapsed size
Max saw weight
Max load
Weight
English
84.5 cm
128 × 21.5 × 25 cm
50 kg
150 kg
14.2 kg