Würth POWER START PS700 Operating/Safety Instructions

Operating & Safety Instructions
GENERAL
The Würth 12V Jump Starter PS700 is designed to assist with starting 12 Volt vehicles that have
discharged batteries. To ensure safe and trouble-free operation of your PS700 you must follow the
instructions below.
IMPORTANT INFORMATION FOR YOUR SAFETY
DO NOT SHORT CIRCUIT OR TAMPER WITH THIS UNIT. ALWAYS OBSERVE
CORRECT POLARITY AND SYSTEM VOLTAGE WHEN CONNECTING.
Failure to do so may lead to a HAZARDOUS situation, Damage the pack or the vehicle and
may invalidate the warranty.
Remove personal items such as rings, bracelets and watches when working with a vehicle
battery.
Use PS700 for boosting standard 12 Volt vehicle batteries only.
Switch unit off when not in use.
WARNING
Before initial use, the PS700 must be put on charge overnight (16Hrs). Failure to do so
may reduce the life of the product and invalidate the warranty.
CHARGING
CHECKING STATE OF CHARGE
The state of charge is best checked 2 hours after charging. Ensure all cables are disconnected. Push
the "Push to test" button. The LEDs will indicate the approximate state of charge of the unit.
PS700
1