1. INTENED USE The power tool is intended for driving and drilling through wood and plastics It is not designed for professional use. WARNING! Read this manual and general safety instructions carefully before using the appliance, for your own safety. Your power tool should only be passed on together with these instructions.
5. GENERAL POWER TOOL SAFETY WARNINGS GENERAL POWER TOOL SAFETY WARNINGS WARNING Read all safety warnings, instructions, illustrations and specifications provided with this power tool. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury.
Page 6
h) Do not let familiarity gained from frequent use of tools allow you to become complacent and ignore tool safety principles. A careless action can cause severe injury within a fraction of a second. 4) Power tool use and care a) Do not force the power tool.
b) Brace the tool properly before use. This tool produces a high output torque and without properly bracing the tool during operation, loss of control may occur resulting in personal injury. c) Hold the power tool by insulated gripping surfaces, when performing an operation where the cutting accessory or fasteners may contact hidden wiring.
Page 8
If under extreme conditions any electrolyte should escape from the battery, it's essential to avoid contact with skin. If electrolyte does come into contact with your skin, rinse it off with water. In the event of electrolyte contact with your eyes, it's essential to consult a doctor. This charger can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and...
▪Always remove battery packet before working on the machine ▪When the battery is outside the drill, cover the contacts to avoid short circuits (e.g. from tools) ▪Do not throw batteries into water or fire, risk of explosion! ▪Protect the battery from impacts, and don't open it. ▪Never discharge the battery completely and recharge occasionally if not used for a prolonged period WARNING:...
If the dirt does not come off use a soft cloth moistened with soapy water. Never use solvents such as petrol, alcohol, ammonia water, etc. These solvents may damage the plastic parts. 10. TECHNICAL DATA Model nr. RACPV18V2AC Rated voltage 18V d.c. , (20V max) No – load speed 0-650/min...
Chuck type Keyless chuck Acoustic pressure level LpA 87.6 dB(A), K=5dB(A) Acoustic power level LwA 98.6dB(A), K=5dB(A) Vibration 1.298m/s² K =1,5 m/s² 11. NOISE Noise emission values measured according to relevant standard. ATTENTION! Wear hearing protection when sound pressure is over 85 dB(A). Information: The declared vibration total value has been measured in accordance with a standard test method and may be used for comparing one tool with another;...
BUILDER SAS ZI, 32 rue Aristide Bergès – 31270 Cugnaux – France Declares that the machinery designated below: Drill / Screwdriver RACPV18V2AC S/N: 20220656886-20220666885 is in conformity with the essential requirements and other relevant provisions of the applicable European Directives, based on the application of European harmonized standards. Any unauthorized modification of the apparatus voids this declaration.
11. WARRANTY WARRANTY The manufacturer guarantees the product against defects in material and workmanship for a period of 2 years from the date of the original purchase. The warranty only applies if the product is for household use. The warranty does not cover breakdowns due to normal wear and tear. The manufacturer agrees to replace parts identified as defective by the designated distributor.
12. PRODUCT FAILURE WHAT TO DO IF MY MACHINE BREAKS DOWN? If you bought your product in a store: a) Empty the fuel tank if your product has one. b) Make sure that your machine is complete with all accessories supplied, and clean! If this is not the case, the repairer will refuse the machine.
13. WARRANTY EXCLUSIONS THE WARRANTY DOES NOT COVER: • Start-up and setting up of the product. • Damage resulting from normal wear and tear of the product. • Damage resulting from improper use of the product. • Damage resulting from assembly or start-up not in accordance with the user manual. •...
Page 16
BUILDER SAS 32, rue Aristide Bergès - ZI 31270 Cugnaux – France Made in PRC 2022...
Need help?
Do you have a question about the RACPV18V2AC and is the answer not in the manual?
Questions and answers