Panasonic WV-NF284 Network Operating Instructions page 23

[Unicast port1 (Image)]
Enter the unicast port number (used to transmit image
from the camera).
Available value: 1024 - 50000 (Only even numbers are
available.)
Default setting: 32004
[Unicast port2 (Audio)]
Enter the unicast port number (used to transmit audio
from the camera).
Available value: 1024 - 50000 (Only even numbers are
available.)
Default setting: 33004
[Multicast address]
Enter the multicast IP address.
Images and audio will be transmitted to the designated
IP address.
Available value: 224.0.0.0 - 239.255.255.255
Default setting: 239.192.0.20
[Multicast port]
Enter the multicast port number (used to transmit
MPEG-4 images from the camera).
Available value: 1024 - 50000 (Only even numbers are
available.)
Default setting: 37004
[Multicast TTL]
Enter the multicast TTL value.
Available value: 1 - 254
Default setting: 16
Important:
• Depending on the PC in use for monitoring, the mul-
ticast port number may be already in use. In this
case, it may be impossible to monitor images.
Change the multicast port number.
• When transmitting MPEG-4 image via a network, the
transmitted image sometimes may not be displayed.
In this case, refer to the network administrator.
• When two or more network interface cards are
installed on the PC in use, the network interface
card(s) not used for receiving images should be
invalidated when displaying images using the multi-
cast port.
23