1. Manuals
  2. Brands
  3. CSH Manuals
  4. Indoor Furnishing
  5. Galaxy Series
  6. Assembly

CSH Galaxy Series Assembly

Standard base cabinet
Hide thumbs
1
2
3
4
5
6
7
8

Advertisement

Table of Contents

NEXUS BASE
CABINET
ASSEMBLY
Also applies to: Galaxy,
Nexus, Ridgeline,
Statesman, and
Waterford Series

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Galaxy Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for CSH Galaxy Series

Summary of Contents for CSH Galaxy Series

  • Page 1 NEXUS BASE CABINET ASSEMBLY Also applies to: Galaxy, Nexus, Ridgeline, Statesman, and Waterford Series...

  • Page 2: What You Will Need

    NEXUS SERIES CABINETS STANDARD BASE ASSEMBLY INSTRUCTIONS Also applies to: Galaxy Series, Nexus Series, Ridgeline Series, Statesman Series, and Waterford Series FOR YOUR INFORMATION: These assembly instructions serve as a general guideline for most base cabinets. While the assembly method is basically consistent across cabinet types, the sizes, confgurations, number of shelves, number of drawers, and number of doors may vary.
  • Page 3 B. SLIDING IN THE SIDE PANELS 1. With the face frame lying face down on the protected surface, run a modest bead of glue in the dovetailed channel . 2. Slide the side panel into the groove you just glued. Be sure that the fnished side is facing outside.

  • Page 4: Installing The Back Panel

    E. INSTALLING THE BACK PANEL 1. Apply glue to: (a) the edge of the left side panel (b) the edge of the right side panel (c) the edge of the bottom panel. Screws go here These edges will come into contact with the back panel. 2.
  • Page 5 G. INSTALLING WOOD CORNER BRACES This kit also comes with four wood corner braces. 1. With the top of the cabinet facing you, place one of the wood braces in one of the cabinet corners. The brace needs to be placed against the stringer.
  • Page 6 J. ATTACHING FRONT PANEL TO DRAWER (A) If you chose to assemble the drawer box FIRST, before attaching the face panel, skip this step and move on to Section K - Building the Drawer Box. Otherwise, please read the following instructions. 1.
  • Page 7 M. INSERTING DRAWER BOX INTO CABINET 1. Extend the drawer slides out from the cabinet. 2. Place the drawer box on top of the slides. Pull each slide into the drawer clip. Each clip should securely snap the slide into place. 3.
  • Page 8 (1) & (2) Q. ATTACHING FRONT PANEL TO DRAWER (B) If you have already attached the front panel to the drawer on Section J, please skip this step. 1. Ensure that the cabinet door is shut and the drawer box is pushed all the way in.

This manual is also suitable for:

Nexus seriesRidgeline seriesStatesman seriesWaterford series

Table of Contents