Summary of Contents for VTech Switch&GO Dinos HERO THE TRICERATOPS
Page 1
Instruction Manual ® HERO THE TRICERATOPS HERO THE TRICERATOPS...
Page 3
INTRODUCTION Switch into fun with Switch & Go Dinos Hero the Triceratops! ® Switch this mighty Fire Engine into a tough Triceratops and back in just a few simple steps! Launch the Water Burst and release the Rescue Motorcycle to save the day! Let’s go! Water Burst Button Voice Button LCD Screen...
INCLUDED IN THE PACKAGE Switch & Go Dinos Hero the Triceratops • ® • Quick Start Guide WARNING All packing materials such as tape, plastic sheets, packaging locks, removable tags, cable ties, cords and packaging screws are not part of this toy, and should be discarded for your child’s safety. NOTE Please save this Instruction Manual as it contains important information.
GETTING STARTED WARNING: Adult assembly required for battery installation. Keep batteries out of reach of children. Battery Removal and Installation 1. Make sure the unit is turned Off. 2. Locate the battery cover on the bottom of the unit. Use a screwdriver to loosen the screw and then open the battery cover.
IMPORTANT: BATTERY INFORMATION • Insert batteries with the correct polarity (+ and -). • Do not mix old and new batteries. • Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries. • Only batteries of the same or equivalent type as recommended are to be used.
Page 7
In the UK, give this toy a second life by disposing of it at a small electricals collection point* so all of its materials can be recycled. Learn more at: www.vtech.co.uk/recycle www.vtech.com.au/sustainability * Visit www.recyclenow.com to see a list of collection points near you.
PRODUCT FEATURES 1. Off/Low/High Volume Switch To turn the unit On or to adjust the volume, slide the Off/Low/High Volume Switch to the Low or High volume position. To turn the unit Off, slide the switch to the Off position. 2.
Page 9
6. LED Lights The LED lights flash along with the sounds in Dino mode and Vehicle mode. 7. AUTOMATIC SHUT-OFF To preserve battery life, Hero the Triceratops will automatically shut off after approximately 20 seconds without input. The unit can be turned on again by pressing the Voice Button or by switching between Dino and Vehicle modes.
Page 10
3. Adjust the water launcher 4. Aim the water launcher backwards. forwards. 5. Flip up the tail. 6. Flip out the rear legs. 7. Flip the rear legs up. 8. Rotate the lower legs up.
Page 11
9. Rotate the lower legs. 10. Flip the front legs up. 11. Rotate each front leg and 12. Flip the front bumpers out. shoulder. 13. Push the front bumpers 14. The unit is now in and wheels in. Vehicle mode. To switch back to Dino mode, reverse the steps above.
CARE & MAINTENANCE 1. Keep the unit clean by wiping it with a slightly damp cloth. 2. Keep the unit out of direct sunlight and away from any direct heat sources. 3. Remove the batteries if the unit will not be in use for an extended period of time.
Read our complete warranty policy online at vtech.co.uk/warranty. Australian Customers: VTECH ELECTRONICS (AUSTRALIA) PTY LIMITED – CONSUMER GUARANTEES Under the Australian Consumer Law, a number of consumer guarantees apply to goods and services supplied by VTech Electronics (Australia) Pty Limited. Please refer to vtech.com.au/consumerguarantees for further information.
Need help?
Do you have a question about the Switch&GO Dinos HERO THE TRICERATOPS and is the answer not in the manual?
Questions and answers