Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for VTech Switch&Go Dinos Sandstorm The Stegosaurus
Summary of Contents for VTech Switch&Go Dinos Sandstorm The Stegosaurus
- Page 1 Parent’s Guide Sandstorm the Stegosaurus 91-003479-001...
- Page 3 INTRODUCTION ® ® Thank you for purchasing VTech Switch & Go Dinos Sandstorm the Stegosaurus! Sandstorm can be switched between a mighty Stegosaurus and a cool beach buggy! Let’s go and explore! LCD Screen On/ Off Switch Alignment Dial Sound Effect Button...
-
Page 4: Included In This Package
INCLUDED IN THIS PACKAGE One Sandstorm the Stegosaurus • • One remote control • One parent’s guide WARNING: All packing materials such as tape, plastic sheets, packaging locks, removable tags, cable ties and packaging screws are not part of this toy, and should be discarded for your child’s safety. -
Page 5: Getting Started Battery Installation
GETTING STARTED BATTERY INSTALLATION 1. Make sure Sandstorm the Stegosaurus and the remote control are turned OFF. 2. Locate the battery covers on the back of Sandstorm the Stegosaurus and of the remote control. Use a screwdriver to loosen the screws. 3. -
Page 6: Battery Notice
BATTERY NOTICE • Use new alkaline batteries or fully charged NI-MH (Nickel Metal-hydride) • Use only batteries of the same or equivalent type as recommended. • Do not mix different types of batteries: alkaline, standard (carbon- zinc) or rechargeable, or new and used batteries. •... -
Page 7: Product Features
PRODUCT FEATURES 1. ON/ OFF SWITCH Slide the REMOTE CONTROL ON/OFF SWITCH to to turn the REMOTE CONTROL ON. Slide the Sandstorm the Stegosaurus ON/OFF SWITCH to turn Sandstorm ON. The REMOTE CONTROL and Sandstorm the Stegosaurus must both be turned on to send and receive signals. - Page 8 6. SIGNAL INDICATOR ON THE REMOTE CONTROL The SIGNAL INDICATOR will flash once when a button is pressed. It will light up when any button on the remote control is held down. NOTE: If the signal indicator is not lighting up when any button is pressed, please replace the batteries of remote control with new ones.
-
Page 9: Automatic Shut Off
10. AUTOMATIC SHUT OFF To preserve battery life, Sandstorm the Stegosaurus will shut off automatically after several minutes without input. When Sandstorm the Stegosaurus shuts off automatically, it will not receive any signal sent by the remote control. Sandstorm can be turned on again by sliding the ON/OFF SWITCH to the off, then the on position. - Page 10 TRANSFORMATION 1. From Dino to Vehicle Firstly, push the tail down. Secondly, grip under the two front wheels with one hand. Thirdly, use another hand to push the top lights towards tail until the head locks and rests into the body. Finally, f ip up the front claws.
-
Page 11: Care And Maintenance
2. From Vehicle to Dino Firstly, pull the tail up to pop out the head. Secondly, fold down the front claws. CARE & MAINTENANCE 1. Keep Sandstorm the Stegosaurus and the remote control clean by wiping them with a slightly damp cloth. 2. -
Page 12: Troubleshooting
DECLARATION OF CONFORMITY Hereby, VTech Electronics Europe BV declares that the radio equipment type of the above models are in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.vtech.com/re-directive... - Page 15 Visit our website for more information about our products, downloads, resources and more. www.vtech.co.uk TM & © 2018 VTech Holdings Limited. All rights reserved Printed in China 91-003479-001...
Need help?
Do you have a question about the Switch&Go Dinos Sandstorm The Stegosaurus and is the answer not in the manual?
Questions and answers