Message Display - Panasonic Lumix DMC-LX2 Operating Instructions Manual

Message Display

Confirmation messages or error messages will be displayed on the screen in some cases.
The major messages are described below as examples.
[THIS MEMORY CARD IS PROTECTED]
Cancel the card lock. (P18, 101)
[NO VALID PICTURE TO PLAY]
Play back after recording or after inserting
a card with a recorded picture.
[THIS PICTURE IS PROTECTED]
After canceling the protect setting (P101),
you can delete or overwrite the picture.
[THIS PICTURE CANNOT BE DELETED]/
[SOME PICTURES CANNOT BE
DELETED]
The pictures not based on the DCF
standard cannot be deleted.
• To delete this kind of picture, first save
your data to your computer, then use this
unit to reformat the card. (P106)
[NO ADDITIONAL DELETE SELECTIONS
CAN BE MADE]
• You have exceeded the number of pictures that
can be set at once with multi-delete setting.
• You have placed more than 999 pictures
in your favorites list.
[CANNOT BE SET ON THIS PICTURE]/
[CANNOT BE SET ON SOME PICTURES]
If the pictures are not based on the DCF
standard, the DPOF print cannot be set.
[NOT ENOUGH SPACE ON BUILT-IN
MEMORY]/[NOT ENOUGH MEMORY IN
THE CARD]
There is no space left on the built-in
memory or the card.
• When you copy pictures from the built-in
memory to the card (batch copy), the
pictures are copied until the capacity of
the card becomes full.
120
VQT0Y44
Others
[SOME PICTURES CANNOT BE
COPIED]/[COPY COULD NOT BE
COMPLETED]
The following pictures cannot be copied.
• When a picture with the same name as
the picture to be copied exists in the copy
destination.
• Files not based on the DCF standard.
Moreover, pictures recorded or edited by
other equipment may not be copied.
[BUILT-IN MEMORY ERROR
FORMAT BUILT-IN MEMORY?]
This message will be displayed when you
format the built-in memory on the PC or
remove the battery without turning the
camera off. Format the built-in memory of
the camera again. (P106) The data on the
built-in memory will be deleted.
[MEMORY CARD ERROR
FORMAT THIS CARD?]
The format of the card cannot be
recognized by this camera. Format the card
again with this camera.
Save your data to your computer, then use
this unit to reformat the card. (P106)
[REMOVE LENS CAP AND PRESS q
BUTTON]
This message appears when the lens cap is
left on the activated camera or when you
exert pressure on the lens with your hand etc.
and the camera does not operate properly.
• Remove the lens cap and press q when
the lens cap is on.
• Turn the camera off and on when the lens
cap is removed.
If the message persists, contact the dealer or
your nearest servicenter.