Panasonic Lumix DMC-LX2 Operating Instructions Manual page 108

n Folder Composition
Folders appear as follows.
D C I M
• Built-in
memory
• Card
M I S C
PRIVATE1
Folder number
1
File number
2
JPG : Pictures
3
MOV : Motion pictures
RAW : RAW format files
The contents of each folder are:
DCIM 100_PANA to 999_PANA
100_PANA to Pictures/Motion pictures/
999_PANA Pictures in RAW files
MISC File with DPOF setting
PRIVATE1 Flip animation files
• This unit stores up to 999 picture files in
each folder. A new folder is created after
this maximum is reached.
• To reset file and folder numbers, use
[NO.RESET] in the setup menu. (P24)
108
VQT0Y44
Connecting to other equipment
100_PANA
1
100_PANA
P1000001.JPG
2 3
P1000002.JPG
P1000999.JPG
101_PANA
999_PANA
n Conditions under which a different
folder number is used
In the following cases, the picture is not
recorded in the same folder as the
previously recorded picture. It is recorded
in a folder with a new number.
• The folder containing the picture you just
shot had a file numbered 999 in it
(example: P1000999.JPG).
• When the card just recorded to contains,
for example, a folder with the number 100
(100_PANA) in it and that card is removed
and replaced with a card that has a folder
with the number 100 in it recorded by a
camera from a different maker
(100XXXXX, with XXXXX being the name
of the maker) and then a picture is
recorded.
• You start shooting again after using
[NO.RESET] in the setup menu (P24). (It
is recorded to a new folder that has a
number following on from the one
previous. You can also reset the folder
number to 100 by using [NO.RESET]
immediately after formatting the card
when there are no folders or pictures on
the card.)
n Connection in the PTP mode
Windows XP/Mac OS X users can establish
connection in the PTP mode by setting the
camera in print mode [
it to their PC.
• You can only load pictures from the
camera and cannot write them on the
card or delete them.
• When there are 1000 or more pictures on
a card, the pictures may not be imported.
• When you set the camera in print mode
[ ] and connect it to a PC, [PLEASE
CONNECT TO THE PRINTER] appears
on the camera's LCD monitor. This is not
a malfunction.
] and connecting