Non-Specified Commercial Flashes; Sequential Shooting/Self-Timer/Remote Control; Setting The Functions; Sequential Shooting - Olympus EVOLT E-510 Instruction Manual

Non-specified commercial flashes

1) Exposures when using a flash require that adjustments be made on the flash. If a flash is
used in the auto mode, match it with the f-number and ISO sensitivity settings on the
camera.
2) Even if the flash auto f-number and ISO sensitivity are set the same as on the camera, the
correct exposure may not be obtained depending on the shooting conditions. In such a
case, adjust the auto f-number or ISO on the flash or calculate the distance in the manual
mode.
3) Use a flash with an illumination angle that matches the focal length of the lens. The focal
length of the lens for 35 mm film is approximately twice as long as the focal length of the
lenses designed for this camera.
4) Do not use a flash unit or other accessory TTL flash that has additional communication
functions other than the specified flashes, since it may not only fail to function normally,
but may also cause damage to the camera's circuitry.

Sequential shooting/Self-timer/Remote control

Setting the functions

Direct button
j/Y/< Control dial
• When settings are made with the j/Y/< button, the
information is also displayed on the viewfinder.
Sequential
shooting
:
Single-frame shooting
:

Sequential shooting

Control panel screen
i p: j/</Y i
Sequential shooting
Single-frame shooting o
Sequential shooting j
• Press the shutter button fully and keep it pressed. The camera will take pictures in sequence until
you release the button.
Self-timer Remote control
:
12-second self-timer
:
2-second self-timer
Shoots 1 frame at a time when the shutter button is pressed
(normal shooting mode).
Shoots 12 frames or more at 3 frames/sec. for as long as the
shutter button is pressed (during JPEG). Focus, exposure, and
white balance are locked at the first frame (during S-AF, MF).
j/Y/<
:
0 second
:
2 seconds
button
Control dial
button
i
3
45
EN