Paradyne 8540 Installation Instructions Manual page 6

Digital subscriber line (dsl) card

Hide thumbs Also See for 8540:

Connecting to a POTS Splitter or an MDF

You can connect the HotWire DSLAM chassis containing the 8540 DSL card to a

POTS splitter shelf, MDF, or other demarcation point.

NOTE:

If you are connecting the HotWire DSLAM to a CO POTS splitter, this

procedure assumes that the CO POTS splitter shelf is already installed. For

information on how to install the CO POTS splitter, refer to the HotWire POTS

Splitter Central Office Installation Instructions, Document No. 5020-A2-GN10.

Procedure

To connect the HotWire DSLAM chassis containing the 8540 DSL card to a POTS

splitter shelf or MDF:

1. Plug the Telco 50-pin cable into the appropriate LINE port on the front panel

of the chassis:

— On a HotWire 8600 DSLAM chassis:

October 1997

8540-A2-GN10-00

Table of Contents