UNI-T UTi260V User Manual

PREFACE
Thank you for purchasing the new UTi260V thermal imager. In order to use this product
safely and correctly, please read this manual thoroughly, especially the CAUTIONS part.
After reading this manual, it is recommended to keep the manual at an easily accessible
place, preferably close to the device, for future reference.
LIMITED WARRANTY AND LIABILITY
Uni-Trend guarantees that the product is free from any defect in material and workmanship
within one year from the purchase date. This warranty does not apply to damages caused
by accident,negligence, misuse, modification, contamination and improper handling. The
dealer shall not be entitled to give any other warranty on behalf of Uni-Trend. If you need
warranty service within the warranty period, please contact your seller directly.
This warranty is the only compensation you can obtain. Uni-Trend will not be responsible
for any special,indirect, incidental or subsequent damage or loss caused by any reason or
speculation. As some areas or countries do not allow limitations on implied warranties and
incidental or subsequent damage, the above limitation of liability and stipulation may not
apply to you.
CAUTIONS
1. Use or store the product at specified operating or storage temperatures.Otherwise, the
device may be damaged.
2. Do not direct the product at high intensity thermal radiation sources, such as the sun, laser
device, spot-welder, etc.
3. Do not knock, toss, or shake the product and accessories.
4. Do not place the battery in a high temperature environment or near high temperature
objects. Do not short-circuit the positive and negative electrodes of the battery. Do not
place the battery in a humid environment or water.
5. Do not expose the device to dusty or damp environment. When used in an environment
with water, avoid water splashing on the product.
6. Do not use dissolved or similar liquids on the product or cables, as it may cause device
damage.
7. Please follow the following instructions when wiping the device:
Non-optical surface: If necessary, use a clean and soft cloth to wipe the non-optical surface
of the thermal imager.
Optical surface: Do not stain the optical surface of the lens when using the thermal imager.
Be especially careful not to touch the lens with hands, as sweat from hands will leave
marks on the lens glass and may erode the optical coating layer on the glass surface.
When the optical surface is stained, carefully wipe it with a special lens paper.
8.
When using the device, please try to keep it stable and avoid violent shaking.
16