Advertisement
Advertisement
Table of Contents
Related Manuals for Cair Move
Summary of Contents for Cair Move
- Page 1 Smart Technology, Made to Care Move Quick Reference Guide we-cair.com...
-
Page 2: Table Of Contents
Contents ● Page 3 - Preparing and Switching On ● Page 4 - Walk Test Mode ● Page 5 - Normal Operation ● Page 6 - Registering to a Notifier / Other System Page 7 - Installation ● ● Page 8 - Turning Off and Factory Reset Smart Technology, Made to Care... -
Page 3: Preparing And Switching On
The Move will turn on once the battery isolation strip has been removed. The LED will flash red and then green to indicate a good battery, or red again to indicate a low battery. The device will warm-up and after 30 seconds the Move will then enter Walk Test Mode for 2 minutes. -
Page 4: Walk Test Mode
Move Walk Test Mode When the unit is first switched on, after the 30 second warm-up period, it will enter walk test mode for 2 minutes. When in walk test mode, the LED will flash red each time movement is detected, as well as sending a radio message. -
Page 5: Normal Operation
Move Normal Operation After the two minute walk test mode has ended, the Move will enter normal operation mode. When in this mode, a radio message will be sent every time movement is detected; the LED will not flash during normal operation. During normal operation, initially movement will be detected immediately, followed by a 30 second detection delay before further detections can occur. -
Page 6: Registering To A Notifier / Other System
Ensure the Move has been switched on and is in Walk Test Mode. ● ● Prepare the Notifier/other system by entering registration mode. Activate the Move using movement in front of the lens, the LED will flash to confirm. ● ● The Notifier/other system should acknowledge the new device. -
Page 7: Installation
Apply pressure to the unit for a few seconds when in position. If the Move is to be screwed to the wall or into a corner, drill through the four screw recesses and use four suitable screws to mount the rear case to the wall, before reassembling the case. -
Page 8: Turning Off And Factory Reset
Move Turning Off and Factory Reset Turning off: Remove the batteries or re-insert the isolation strip. Factory reset: Remove and re-insert the batteries. Smart Technology, Made to Care... -
Page 9: Smart Technology, Made To Care
Thank you Smart Technology, www.we-cair.com Made to Care 01422 399155 helloi@we-cair.com...
Need help?
Do you have a question about the Move and is the answer not in the manual?
Questions and answers