Hide thumbs Also See for Core EMG:

Advertisement

Core EMG Quick Start Guide
Quick Start Guide
1
(Rev B)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Core EMG and is the answer not in the manual?

Questions and answers

Summary of Contents for Noraxon Core EMG

  • Page 1 Core EMG Quick Start Guide Quick Start Guide (Rev B)
  • Page 2 Ultium EMG User Manual (#P-8848) for more detailed operating instructions for the Core EMG System. 1 System Unboxing The Core EMG System is packed within a reinforced padded box for storage and protection during transport. Upon receiving the package, carefully remove all contents and verify the following components are present.
  • Page 3: Installing The Hardware

    To utilize the full functionality of the Core EMG system, and ensure the system has updated drivers, Noraxon’s myoRESEARCH (MR) needs to be installed on the computer. Note: The Core Hub requires the Noraxon USB device driver which is pre-installed by the MR3 software installation. It is also available in the Downloads section of the Noraxon website.
  • Page 4: Configuring The Hardware

    4 Configuring the Hardware Before the Core EMG system can be used, the device software settings must be configured to recognize the different components that make up the system. Follow the instructions below to update the hub firmware, sensor firmware, and populate sensors to prepare for data collection.
  • Page 5 RF networks assignments are required for each Receiver. Step 4 Make sure the Core EMG Sensors are placed in the Hub, then click Detect Sensors in Chargers to load all sensor serial numbers into the MR software. Note: The first serial number in the list is associated with the Sensor closest to the front of the Charger (i.e.,...
  • Page 6: Recording A Measurement

    Select an application, then select or create a new protocol. Click MEASURE to proceed. Step 2 Insert the Core EMG device into the configuration by dragging it from the Available Devices list to the Devices in Your Configuration area. Step 2 Select the channels to include in the measurement by clicking the checkmark.
  • Page 7: Viewing A Record

    Core EMG Quick Start Guide 6 Viewing a Record To view a previously recorded measurement, click the Database tab. Records are organized by subject name and date measured. Select and click VIEW or double-click on the record of interest to open the record in the View tab.
  • Page 8 Core EMG Quick Start Guide (Rev B)

Table of Contents