Rear - NEC NP300 User Manual

Rear

Ventilation (inlet) / Filter Cover
(→ page 76)
Terminal Panel (→ page 8)
AC Input
Connect the supplied power cable's two-pin plug here, and
plug the other end into an active wall outlet. (→ page 25)
Main Power Switch
When you plug the supplied power cable into an active wall outlet
and turn on the Main Power, the POWER indicator turns orange
and the projector is in standby mode.
(→ page 26, 38)
6
Lamp Cover (→ page 80)
Monaural Speaker (7W)
Ventilation (outlet)
Heated air is exhausted from here.
Spacer (black rubber)
To fine-adjust the height of the rear foot,
remove the spacer and rotate the rear
foot to the desired height.
Rear Foot (→ page 31)
1. Introduction