Maytag MVWX700X Use And Care Manual page 12

TROUBLESHOOTING
First try the solutions suggested here or visit our website at www.maytag.com/help
If you experience
Water Leaks
Check the following for
proper installation:
Washer not performing as expected
Not enough water
in washer
Washer won't run
or fill, washer stops
working or wash light
remains on (indicating
that the washer
was unable to fill
appropriately)
Washer won't run
or fill, washer stops
working or wash light
remains on (indicating
that the washer
was unable to fill
appropriately) (cont.)
12
for assistance and to possibly avoid a service call.
Possible Causes
Washer not level.
Fill hoses not attached tightly.
Fill hose washers
Drain hose connection
Check household plumbing for leaks
or clogged sink or drain.
Washer not loaded properly.
Load not completely covered
in water.
Check for proper water supply.
Check for proper electrical supply.
Water may splash off basket if washer is not level.
Tighten fill-hose connection.
Make sure all four fill hose flat washers are properly seated.
Pull drain hose from washer cabinet and properly secure it to
drainpipe or laundry tub.
Water can back up out of a clogged sink or drainpipe. Check
all household plumbing for leaks (laundry tubs, drain pipe,
water pipes, and faucets.)
Unbalanced loading can cause basket to be out of alignment
and cause water to splash off tub. See "Using Your Washer"
for loading instructions.
This is normal operation for an HE low-water washer. The load will
not be completely underwater. The washer senses load sizes and
adds correct amount of water for optimal cleaning. See "What's
New under the Lid."
IMPORTANT: Do not add more water to washer. The added water
lifts the load off the washplate, resulting in less cleaning.
Both hoses must be attached and have water flowing to
inlet valve.
Both Hot and Cold water faucets must be turned on.
Check that inlet valve screens have not become clogged.
Check for any kinks in inlet hoses, which can restrict water flow.
Plug power cord into a grounded 3 prong outlet.
Do not use an extension cord.
Ensure there is power to outlet.
Reset a tripped circuit breaker. Replace any blown fuses.
NOTE: If problems continue, contact an electrician.
Solution