Connecting Ptz Cameras - Appendix #6 - Lorex SG17LD800 Instruction Manual

Connecting PTZ Cameras - Appendix #6

Connecting PTZ Cameras - Appendix #6
PTZ Cameras (not included with this system) can be connected to the PTZ Control Block on the
back panel of the System. The PTZ Controls are enabled through the Menu system on the
Observation System. Additional PTZ Cameras are available at http://www.lorexcctv.com
Installing a PTZ (RS-45 Type) PTZ Camera:
1. Connect the Transmit Cable to the D+ port on the PTZ Control Block on the Observation System.
2. Connect the Receive Cable to the D- port on the PTZ Control Block on the Observation System.
3. Connect the Camera to BNC Channel 1 (DIN Channel 1 must be empty).
4. Configure PTZ Menu options - refer to page 35. The PTZ Camera Settings will depend on the
Type of Camera - refer to the specific Camera Manual for your brand and model of PTZ Camera.
Installing a PTZ (RS-232 Type) PTZ Camera:
1. Connect the Transmit Cable to the TX port on the RS-232 Block on the Observation System.
2. Connect the Receive Cable to the RX port on the RS-232 Block on the Observation System.
3. Connect the Camera to BNC Channel 1 (DIN Channel 1 must be empty).
4. Configure PTZ Menu options - refer to page 35. The PTZ Camera Settings will depend on the
Type of Camera - refer to the specific Camera Manual for your brand and model of PTZ Camera.
74
OBSERVATION SYSTEM
PTZ CAMERA
(Not Included)