Cisco DMRW1000 User Manual page 42

Wireless Home Audio
Exceptions tab. Make sure that
4. Click on the
CiscoMediaPlayer is checked.
CiscoMediaPlayer and click the Add Port
5. Highlight
button. Enter a name in the Name field and enter 8015
in the Port number field. Make sure that TCP is selected
and click OK.
6. Click OK to close the Exceptions window and Windows
Firewall configuration for the Cisco Media Player is
complete.
My devices are not showing up on the main menu
carousel.
Perform each of the following steps until you are able to
locate the devices on your main menu.
Settings > Zones and Libraries and select
Go to
•
Rediscover.
Go to Standby mode by pressing the power button on
•
the front of the unit. Press the power button again to
exit standby mode.
If using the Docking Station for iPod, verify that the
•
connector is properly attached.
If using a USB device, verify that the USB connector is
•
completely connected.
Controller/Wireless-N Touchscreen Remote
My Controller is properly set up but I am not able to
control my Wireless Home Audio Devices.
Ensure that the wireless signal strength indicates that you
have a good wireless connection. If not, you may be out
of range and may need to move closer to your wireless
router or access point.
Wireless Signal Strength
The touch screen is not responding in some areas of the
LCD screen.
Settings > General Settings > Calibrate
1. Go to
Touchscreen.
2. Press the center of the + symbol in the upper left
corner.
3. Press the center of the + symbol in the lower right
hand corner.
4. When the OK appears on the screen, press the center
of the 5-Way button.
Troubleshooting
35