Table of Contents
Advertisement
Wireless Home Audio
Troubleshooting
Do I need to run the CD to configure my Wireless Home
Audio devices?
Yes. Basic settings can be applied on some devices via
their screens, but in order to fully configure your Wireless
Home Audio devices you must use the CD.
My Controller did not include a CD.
The Controller package does not include a CD. The
Controller uses the same software that was included with
your Director, Player, or Conductor. For setup instructions,
refer to Setting Up Your Controller, page 6.
How do I share my music from additional computers and
allow them to control my Wireless Home Audio devices?
Run the CD on your additional computers and select the
Connect Computers option on the first screen.
Where do I find the Cisco Media Center software after
installation is complete?
Go to Start > Programs and select Cisco Media Center.
You can start the Cisco Media Player from here.
What do I do if my iTunes library or other audio files are
not found by Cisco Media Center?
Some iTunes files may not be available. Songs purchased
from iTunes* may be protected with Digital Rights
Management (DRM); DRM files cannot be played to your
Wireless Home Audio devices directly from your PC.
The optional Linksys by Cisco Docking Station for iPod
(MCCI40) will allow you to connect your iPod to your
Director or Conductor and play back all of the songs from
your iPod.
*iTunes Plus files are not protected
†
During the initial configuration, you are asked to select
directories where your music is stored. To change or
add additional directories, right-click on the
on the taskbar and select Properties. Modify or type
in a new directory by typing in the entire path such as
C:\Documents and Settings\username\My Documents\
My Music; in the Local Media Directory field. Additional
directories are separated by a semicolon. Click OK after all
updates are complete.
Controller/Wireless-N Touchscreen Remote
My Cisco Media Server content is not appearing on
my Wireless Home Audio devices, but it seems to be
running.
You may need to reconfigure your Windows firewall. To do
so, perform the following steps:
1.
Go to
Start > Control Panel.
Windows Firewall.
2.
Select
3.
On the
exceptions is unchecked.
icon
Troubleshooting
General tab, make sure that Don't allow
34
Advertisement
Table of Contents
