Table of Contents
Advertisement
This section provides instructions on how to install or replace the card reader.
To replace the card reader, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See "Removing the computer cover" on page 22.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 23.
4. Locate the card reader. See "Locating components" on page 9.
5. Disconnect the card reader cable from the front USB connector on the system board. See "Locating
parts on the system board" on page 10.
6. Press the blue retaining clip to remove the card reader out of the chassis.
Figure 22. Removing the card reader
7. Install the card reader retainer on the side of the new card reader.
Figure 23. Installing the card reader retainer
.
Chapter 4
Installing or replacing hardware
31
Advertisement
Table of Contents
