Recording An Audio Source - Aiwa AV-D30 Operating Instructions Manual

T(I PLAY A DVD RECORDED IN DOLBY
DIGITAL SURROUND
This receiver has the 5.1 INPUT connectors supporting Dolby
Digital decoder with the 5,1 ch output terminals. When a DVD
player that contains a Dolby Digital decoder is connected to the
receiver, you can enjoy theater-quality audio right in your home
when playing discs recorded in Dolby Digital Surround.
1 Press the VIDEO 1/5.1 CH button to select the
VIDEO 1 (DVD or MD) function.
2 Press the VIDEO 1/5.1 CH button again.
"5.1 CH" appears on the display and the DVD player
connected to the 5.1 INPUT terminals is selected as a source,
3 Start playing the DVD recorded in Dolby Digital
Surround.
To resume the VIDEO 1, DVD (2 ch stereo) or MD function, press
the VIDEO 1/5.1 CH button again.
m
The 5.1 CH function is automatically canceled and the VIDEO
1, DVD or MD function is selected:
- when the Dolby Pro Logic is turned on
- when headphones are plugged in
The 5.1 CH function cannot be selected while headphones are
plugged in.
RECORDING AN AUDIO SOURCE
1
2
3
TAPE< MONITOR
1
Select the program source to be recorded.
Press one of the function buttons,
Set the tape deck or MD recorder to the recording
mode.
Start the selected program source.
To monitor recorded sound during recording (wheln the
connected tape deck is a three-head system)
Press the TAPE MONITOR button. "TAPE ON" appears cm the
display for four seconds, and then the source name selected in
step 1 comes back on. To cancel the tape monitor, press it again
so that "TAPE OFF" appears.
m
Any sound controll system has no effect on recording (see page
7).
m
Input sound through the 5.1 INPUT terminals cannot be
recorded. When recording the sound from the DVD player,
connect the AUDIO OUT (DOWN MIXING) terminals of the DV[)
player to the VIDEO l/DVD/MD AUDIO IN terminals of the unit.
ENGL/S,H
1 I()