All LED AFLD10BK/CCT Installation Manual & User Manual

INSTALLATION GUIDE & USER MANUAL
AFLD10BK/CCT
ENSURE POWER SUPPLY IS OFF WHEN HANDLING ANY ELECTRICAL EQUIPMENT.
• This product may need to be installed by a qualified electrical installer.
• Please read this guide in its entirety to fully understand the products before attempting any install.
• All electrical work should be completed in accordance with the latest IET regulations, and/or any other relevant rules,
regulations or laws of the country in which it is being installed.
• The item must be installed in isolation from any insulating material and be adequately ventilated to prevent premature
failure.
• Ensure power supply is isolated prior to installation, maintenance or performing any other form of electrical work.
• In the event of incorrect or improper function with specific regard to any of ALL LED's products and contact ALL
LED for further advice.
Technical Specifications
Product Code
Luminous Flux (LM)
Useful Luminous Flux (LM)
CCT (Kelvin)
Beam Angle (°)
SDCM
CRI
Peak Intensity (cd)
Operating Voltage (V)
Max Output Power (W)
Operating Current (A Max)
Standby Power (W)
Power Factor (Pf)
Class
Body Material
Frame Colour
Switching Cycles
Ingress Protection
Ambient Operating Temperature (°C)
Input Frequency (Hz)
Guarantee
Cable Length
Lifetime (L70 B50)
Survival Factor
Lumen Maintenance Factor
Flicker Metric (PstLM)
PLEASE READ
BEFORE USE!
AFLD10BK/CCT
640lm 680lm 670lm
460lm 490lm 480lm
3000K 4000K 6000K
110°
<6
>80
304cd 323cd 317cd
220-240V AC
10W
0.068A
<0.5W
0.66
I
Aluminium
Carbon Black
30,000
IP65
-20°C ~ +45°C
50-60Hz
3 Years
1m
30,000 Hrs
0.9
0.1
<1
!
Installation Instructions
1
4
Adjust the
desired angle
(both side)
• Hold the product in position and mark the location of the fixing holes. The bracket can be removed from the
fitting for ease of installation.
• Fix the bracket to the wall using expansion bolts (not supplied). Take care to avoid damaging any concealed
wiring and pipes. The correct fixings should be used for brick or cavity walls.
• Using an Allen key (not supplied), loosen the bolts on the side, and adjust the fitting to the desired angle.
• Wire as required.
• Ensure that the cable is not snagged. Re-tighten the bolts.
• Turn on power switch. Light is ready for use.
Dimensions (mm)
32mm
2 3
5 6
Not Supplied
175mm