Kensington 33900 Instruction Manual page 8

You can change the position of any keycap (ShareCentral 2/ShareCentral 5 only), or
switch one of the default keycaps to use one of the additional caps, so that the caps
match the actual devices attached to your ShareCentral.
1. To remove a keycap, press the side of the cap nearest the back of your ShareCentral
(or the bottom if the ShareCentral is mounted on the wall). The side of the cap
nearest the front/top of your ShareCentral pops up. Lift to remove the keycap.
NOTE: Do not press the center of the keycap to remove it. Pressing the center switches
the assigned device between computers.
2. Gently place the new keycap in the opening. A magnetic "snap" indicates that the
cap has been secured into place.
Mounting Your ShareCentral to the Wall
For maximum convenience and to save desktop space, you can mount your
ShareCentral on the wall. You will need two screws (sold separately) that are
appropriate for your wall type.
1. Hold the wall mount template, included in this instruction guide, to the desired
location on
the wall. Mark the positions of the two screws with a pencil.
14
2. Drill or manually screw two screws into the marked positions on the wall. Leave the
screws extended slightly from the wall.
3. Using the two wall mount holes on the bottom of your ShareCentral, hang the
ShareCentral onto the screws. The front panel should be facing up.
Power Adapter Specifications (ShareCentral 2/ShareCentral 5 only)
If you need to replace the power adapter, be sure to use an equivalent adapter, as
follows:
• For ShareCentral 2 model 33900: 5V 1A (minimum)
• For ShareCentral 5 model 33901: 5V 2.5A (minimum)
NOTE: For ShareCentral 1 model 33903 the power adapter is not required. If the USB
peripheral attached to the ShareCentral 1 needs to be powered through the USB
interface of the Share Central 1, then a 5V 1A (minimum )
is recommended.
power adapter
15