Table of Contents
Advertisement
Quick Links
Operating Instruction and safety manual
1/2" Heavy Duty Air Impact Wrench
Residual risks
Even when the tool is used as prescribed it is not possible to eliminate all residual risk factors. The
following hazards may arise in connection with the tool's construction and design:
1. Damage to lungs if an effective dust mask is not worn.
2. Damage to hearing if effective hearing protection is not worn.
3. Health defects resulting from vibration emission if the power tool is being used over longer period of time or not
adequately managed and properly maintained.
4.
Wear eye protection.
1
Air Impact Wrench 17407
Model : 17407
IMPORTANT:
Upon receipt of the product,
read and follow all safety rules,
operating instructions before first use it.
And retain this manual for future reference.
2013
2014
Advertisement
Table of Contents
Related Manuals for Aeropro 17407
Summary of Contents for Aeropro 17407
- Page 1 2. Damage to hearing if effective hearing protection is not worn. 3. Health defects resulting from vibration emission if the power tool is being used over longer period of time or not adequately managed and properly maintained. Wear eye protection. 2013 2014 Air Impact Wrench 17407...
-
Page 2: Technical Data
Do not modify this assembly power tool for threaded fasteners. Modifications can reduce the effectiveness of safety measures and increase the risks to the operator. Do not discard the safety instructions; give them to the operator. Do not use the assembly power tool for threaded fasteners if it has been damaged. Air Impact Wrench 17407... -
Page 3: Repetitive Motions Hazards
-and-stop device in the case of an interruption of the energy supply. -ended crow-foot nutrunners. ing hands between tool and workpiece, especially when unscrewing. Repetitive motions hazards or other parts of the body. power tool for threaded fasteners, the operator should adopt a comfortable posture Air Impact Wrench 17407... -
Page 4: Accessory Hazards
(ringing, buzzing, whistling or humming in the ears). ⎯ amping materials to prevent workpieces from “ringing”. safety regulations. as recommended in the instruction handbook, to prevent an unnecessary increase in noise levels. Air Impact Wrench 17407... -
Page 5: Vibration Hazards
4. Drain the air tank daily. Water in the air line will damage the wrench. 5. Clean air inlet filter weekly. 6. Line pressure should be increased to compensate for unusually long air hoses (over 8 metres). The hose diameter should be 3/8” I.D. Air Impact Wrench 17407... -
Page 6: Loading And Operation
7. Make children away from the tools and workplaces. DO NOT use any additional force upon the wrench in order to remove a nut. DO NOT allow wrench to free run for an extended period of time as this will shorten its life. Air Impact Wrench 17407... -
Page 7: Maintenance
■ Disconnect supply. Free motor by rotating drive shank manually where applicable ■ „O‟ rings throttle valve ■ Replace „O‟ ring. Tool will not shut off dislodged from seat inlet valve. Note: Repairs should be carried out by a qualified person. Air Impact Wrench 17407... - Page 8 Anvil Collar cylinder Bearing O-ring7.5*1.8 Rear cover Bolt Plug elastic Anvil bushing Valve pin cylindrical pin Hammer Cage Gasket O-ring Valve spring Hammer Pin Gunbody Trigger Inlet connector Hammer Dog End seal Seal O-ring O-ring 38*1.8 Air Impact Wrench 17407...
Need help?
Do you have a question about the 17407 and is the answer not in the manual?
Questions and answers