Using The Timers; Setting The Clock; Fixing The Clock - JVC MX-KC4J Instructions Manual

Using the Timers

STANDBY/ON
SLEEP
AUX
FM /AM
FM MODE
CD
1 2 3
CD CD CD
REPEAT PROGRAM /RANDOM
A B
TAPE TAPE
SOUND
VOLUME
MODE
FADE
MUTING
RHYTHM AX
REMOTE CONTROL
Three types of timers are available:
DAILY Timer
Use this timer to set wake up everyday to music from any
source, instead of an alarm clock.
REC (Recording) Timer
Unattended recording of radio broadcasts. You can set the
starting time and ending time.
SLEEP Timer
Fall asleep and have your System turn off automatically after
a certain length of time.

Setting the Clock

When you plug the AC power cord into the wall outlet, the time in-
dication "AM 12:00" blinks on the display.
You can set the clock whether the System is on or off.
Using the Unit
1
Press the CLOCK/TIMER button.
The hour digit of the time indication blinks on the display.
4 ¢
2
Press the or
Pressing the ¢ button moves the time forwards and pressing
the 4 button moves it backwards. Holding down the button
moves the hour rapidly.
3
Press the SET button.
The minute digits of the time indication blink on the display.
• To return to the hour setting, press the CANCEL button.
4 ¢
4
Press the or
5
Press the SET button.
"CLOCK OK" appears on the display. Then, the selected time
is set and the seconds start counting from 0.
SLEEP
CLOCK/TIMER
SET
SLEEP indicator
REC (Recording) Timer indicator
Timer indicator
* When the System is in use, the display shows other items as well.
For simplicity, we show here only the items described in this section.
button to set the hour.
button to set the minute.
DAILY Timer indicator

Fixing the Clock

Using the Unit
1
Press the
on the System.
2
Press the CLOCK/TIMER button repeatedly
until clock setting display (time indication)
appears on the display.
Each time you press the button, display changes as follows:
DAILY = ON TIME = REC = ON TIME = Clock Setting
display (time indicator) = Canceled = (back to the beginning)
3
Press the SET button.
The hour digits of the current clock blink on the display.
4
Follow steps 2 to 5 of "Setting the Clock" men-
tioned above.
• The clock must be correctly set for the timers to work.
• Each setting step must be completed within approx. 30
seconds. Otherwise, the setting is cleared and must be
repeated from the beginning.
• The clock may gain or lose one to two minutes per month.
• If there is a power failure, the clock loses its setting
immediately. "AM 12:00" blinks on the display and the
clock must be reset.
¢
4
STANDBY/ON button to turn
20