Cable Box And/Or Dbs Receiver Control Setting (Dvd Deck Only) - JVC SR-MV30US Instruction Manual

INITIAL SETTINGS
22
EN
Cable Box and/or DBS Receiver Control
Setting (DVD Deck Only)
The following procedure is required if you receive your TV
channels through a cable box (descrambler) and/or if you receive
satellite channels through DBS (Direct Broadcast Satellite)
receiver. The Controller allows the unit to automatically switch the
cable box or DBS receiver's channel during timer recording.
NOTES:
The Controller is effective for "VCR Plus+
( pg. 41), "Manual Timer Programing" (
Timer Programing" ( pg. 43).
When connecting your cable box, refer to its instruction manual.
Installing Controller
1
If both a cable box and a DBS receiver are used, position the
Controller so its signal reaches the receiving windows of both the
cable box and DBS receiver.
2
Fix securely using the adhesive strip attached on the back of the
Controller.
Your unit
3
Connect the controller to the unit.
a
Cable box or DBS receiver
Controller
® Timer Programing"
pg. 42), or "On-Disc
Cable box or DBS receiver
Controller
(suggested locations)
To RF output To Audio/video
output
Transmitter
or
To VHF/UHF IN To AUDIO/
(DVD) VIDEO INPUT
Your unit
CABLE
BOX
If your cable box or DBS receiver does not have audio/video
output connectors
Connect the RF output connector on the cable box or DBS receiver
to the VHF/UHF IN (DVD) connector on the rear of your unit via
antenna splitter.
If your cable box or DBS receiver has audio/video output
connectors
Connect the audio/video output connectors on the cable box or
DBS receiver to the AUDIO/VIDEO INPUT connectors on the rear
of the unit.
If both a cable box and a DBS receiver are used, it is recommended
that you connect the DBS receiver to your unit's AUDIO/VIDEO
INPUT connectors and the cable box to your unit's VHF/UHF IN
(DVD) connector via antenna splitter.
4
Connect the Controller to the CABLE BOX connector on the rear
panel.
VCR/DVD
ENTER
SET UP
Setting Brand And Channel
After installation, set the cable box or DBS receiver's brand and
channel correctly; otherwise, the Controller cannot work correctly.
Turn on the unit.
Turn on the TV and select the video channel (or AV mode).
Slide the TV/CABLE/DBS/DVD switch to DVD.
1
Turn on the cable box or DBS receiver.
2
Press VCR/DVD repeatedly so that the DVD lamp lights up on
the unit.
3
Press SET UP to access the Main Menu screen.
4
Press w e to select "INITIAL SET UP", then press ENTER.
5
Press w e to select "STB SET", then press ENTER.
6
Press rt to select "CABLE
BOX SET" or "DBS RECEIVER
SET", then press ENTER.
7
Press rt to select "CABLE
BOX OUTPUT CH" or "DBS
RECEIVER OUTPUT CH", then
press ENTER.
1 2 3
4 5 6
7 8 9
0
rtw e