Important Note - Reverie R310LP Owner's Manual

HEAD AND FOOT
ADJUSTMENTS (A,C)
Adjusts the head and foot sections
to the desired positions.
FLAT (B)
Returns both head and foot to the
flat position.
REMOTE LOCKOUT FEATURE
(A,B)
We created the remote lockout
feature to help owners prevent
unintended use of the base.
Activating Remote Lockout
At the same time, press and hold
the HEAD UP and FLAT buttons
for 3 seconds. The LED will flash
twice to indicate activation. Pressing
any buttons on the remote while
in lockout mode will result in no
movement from the power base.
Deactivating Remote Lockout
Repeat the same process, press
and hold the HEAD UP and FLAT
buttons at the same time for 3
seconds. The LED will flash twice
to indicate deactivation. The remote
and power base will work normally.
NOTE: This power base
may have minor intermittent
performance due to RF
Interference. This is a normal
operation of the power base and
is not a defect.
NOTE:
Please remember to recycle all
electronics.
Remote Control Operation Guide
A. RAISE & LOWER HEAD SECTION
B. RETURN TO FLAT
C. RAISE & LOWER FOOT SECTION
ADDITIONAL REMOTE FEATURES:
• The buttons are back-lit when
a button is pressed, to aid the
visibility of the remote in low light
environments.
• This Base uses a RF (Radio
Frequency) remote control system.
• The included remote is already
paired with your power base, so
should be operational right out of
the box. Please test some of the
features to ensure functionality.
• Only replacement remote controls
require pairing instruction on
following pages. If you find that
your remote is not paired with the
bed, please follow those Bluetooth
pairing instructions.
NOTICE: Changes or
modifications not expressly
approved by the party
responsible for compliance
could void the user's authority to
operate the equipment.

IMPORTANT NOTE:

To comply with the FCC RF
exposure compliance requirements,
no change to the antenna or the
device is permitted. Any change
to the antenna or the device could
result in the device exceeding the
RF exposure requirements and
void user's authority to operate the
device.
NOTE: This device complies
with part 15 of the fcc rules.
Operation is subject to the
following two conditions: (1) This
device may not cause harmful
interference (2) This device
must accept any interference
received, including interference
that may cause undesired
operation.