Important Unpacking Instructions - Reverie R310LP Owner's Manual

IMPORTANT UNPACKING
INSTRUCTIONS
To avoid damage to the power
base, always open the carton
while the power base is laying in
the FLAT position on the floor.
OPEN FLAT
Package contents:
Remote Control
Mattress Retainer Bar
Power Adapter
Base Legs
Y-cable
(optional for Tandem control)
STEP 1
Carefully pull the folded power
base unit out of the shipping carton.
Remove and discard the plastic bag.
Unfold the base keeping the unit top
side down. For safety reasons, this
should be performed by 2 people.
WARNING: PACKAGING
MATERIAL MAY SMOTHER
SMALL CHILDREN AND PETS
STEP 2
Remove the securing fasteners on
the accessory components, and set
them aside from the undercarriage
of the base.
STEP 3
Remove the zip ties securing the
excess cord from the motors of the
power base.
STEP 4A
If the power base is supposed to be
used on a platform or storage bed
without legs, carefully flip the power
base over with at least 2 people and
place it on top of the platform. Make
sure that none of the cords are getting
crushed between the power base and
the platform bed. (For non-platform
setup, skip to Step 4B.)
WARNING: Check with your
platform frame's manufacturer
to ensure that the frame can
support the additional weight of the
power base. Reverie will not be
responsible for damage caused to
your platform frame.
STEP 4B
If the base is going to be used
independently, assemble the power
base legs. Screw them in a clockwise
direction into the threaded holes in the
frame. Carefully flip the power base
over with at least 2 people, to the
upright position.
ATTENTION!
Improper handling
DO NOT lean the
power base against
the installed legs to
flip it over.
STEP 5
Plug the power cord into a grounded
electrical outlet.
WARNING: POWER CORDS MUST
NOT INTERFERE WITH ANY
POWER BASE MECHANISMS
NOTE: An electrical surge protection
unit is recommended (not included)
3
Frame Assembly Instructions
STEP 6
Insert the mattress retainer bar into
the two mount holes located at the
foot end of the power base.
STEP 7
If you are installing a headboard,
proceed to follow the Headboard
Bracket Assembly Guide on our
website. If not, place your mattress
on top of the power base. Power
base assembly is now complete.
Register Online. For easy registration
of your warranty visit
https://reverie.com/register-your-
warranty
Please prepare a digital copy of your
proof of purchase (invoice or sales
receipt) when registering online. You
may be required to provide the Serial
Number for registration, you can find it
on the Law Tags attached to the base.
Manufactured by Reverie
For Warranty and Service:
1-800-973-8374
customerservice@reverie.com
Please have your receipt ready and
Thank you and enjoy your power base.
www.reverie.com
®
available.