Using The Remote Id Function; Using As A Wired Remote Control; Laser Pointer - Hitachi CP-SX12000 User Manual

Remote control

Using the REMOTE ID function

This is the function to define which projector is controlled by the remote control. Utilize
this function when you use some projectors of the same type at the same time.
1.
Set the ID number to the projector beforehand,
referring to the item "REMOTE ID" item (52).
2.
Press a ID button on the remote control. The ID button
selected will light for 3 seconds.
NOTE
• Each time you press any button (except ID buttons), the ID button of
current selected ID number will light.
• To confirm the projector's current ID, press any ID button for 3 seconds. Its
number will be shown on each screen regardless of set ID of projector.

Using as a wired remote control

The accessory remote control works as a wired remote control,
when the wired control port at the bottom of the remote control
connects with the REMOTE CONTROL port on the back of the
projector via an audio cable with 3.5 diameter stereo mini plugs.
This function is useful when a wireless remote signal
may not reliably reach the projector.
NOTE
• To connect the remote control with the projector, use an audio cable
with 3.5 diameter stereo mini plugs.

Laser pointer

This remote control has a laser pointer in place of a finger or rod. The laser beam
works and the LASER INDICATOR lights while the LASER button is pressed.
or
IEC60825-1 :1993 IEC60825-1 :2007
+A1 :1997
+A2 :2001
WARNING ►Use the laser beam of the remote control only for the pointer
on the screen. Never hit eyes by the laser beam since the laser beam can
injure eyes. Do not apply the laser beam to anything except the screen.
CAUTION ►Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous radiation exposure.
18
EN60825-1 :2007
AC IN
I O
Laser aperture
[Class 2 Laser product] Wave length: 650nm,
Maximum output: 1mW, No beam divergence
[Laser Diode] Wave length: 650nm, Maximum power:
6mW, Beam divergence: 30deg (perpendicular)
/8deg (parallel)
LASER
INDICATOR
STANDBY/ON MY SOURCE
ID 1 ID 3
ID 2 ID 4
BLANK
ENTER
FREEZE
SHUTTER
ASPECT
PbyP AUTO
LAN
MONITOR
HDMI DVI-D
OUT
CONTROL IN CONTROL OUT REMOTE
S-VIDEO
CONTROL
IN
COMPUTER IN1 COMPUTER IN2
OUT
MY BUTTON
BNC
VIDEO 1
1 3
R/Cr/Pr G/Y B/Cb/Pb H V VIDEO 2
Y
Cb/Pb
Cr/Pr
2 4
FOCUS ZOOM
+ +
- -
COMPUTER
VIDEO
DIGITAL
LASER
MENU
RESET
POSITION
MAGNIFY
ON
OFF
KEYSTONE
LENS SHIFT