Using The Remote Id Function; Selecting An Input Signal - Hitachi 8000 Series User Manual

Remote control
ID button

Using the REMOTE ID function

Utilize this function to control specifi c projectors by the remote
control assigned the same ID number when you use multiple
projectors of the same type at the same time.
Assign an ID number to each projector before using the
REMOTE ID item in the SERVICE menu of the OPTION menu
(User's Manual (detailed)74). Press the ID button with the
same ID number as assigned to the projector you are going to
control. The ID button selected will light for several seconds.
NOTE
• Each time you press any button (except ID buttons), the ID button of
current selected ID number will light.
• To confi rm the projector's current ID, press any ID button for 3 seconds. Its
number will be shown on each screen regardless of set ID of projector.
INPUT PORTS button

Selecting an input signal

1.
Press COMPUTER 1 / 2, LAN, USB TYPE A / B, HDMI 1 / 2, COMPONENT,
S-VIDEO or VIDEO button on the remote control.
The port corresponding to each button is selected as below.
Button
COMPUTER 1
COMPUTER 2
LAN
USB TYPE A
USB TYPE B
HDMI 1
HDMI 2
COMPONENT
S-VIDEO
VIDEO
NOTE
• While ON is selected for AUTO SEARCH item in OPTION menu,
the projector will keep checking every port sequentially till an input signal is
detected (User's Manual (detailed)68).
• It may take several seconds to project the images from the USB TYPE B port.
Ports
COMPUTER IN1
COMPUTER IN2
LAN
USB TYPE A
USB TYPE B
HDMI 1
HDMI 2
COMPONENT
S-VIDEO
VIDEO
ID buttons
Buttons for input
ports
3