Summary Safety Indications General Instructions Product description Display description Cooking Modes General notes on cleaning Maintenance Troubleshooting Installation EN 2...
Safety Indications • During cooking, moisture may condense inside the oven cavity or on the glass of the door. This is a normal condition. To reduce this effect, wait 10-15 minutes after turning on the power be- fore putting food inside the oven. ln any case, the condensation disappears when the oven reaches the cooking temperature.
Page 4
and cause the glass to shatter. • The oven must be switched off before removing the removable parts. After cleaning, reassemble them according the instruc- tions. • Only use the meat probe recommended for this oven. • Do not use a steam cleaner or high pressure spray for cleaning operations.
Page 5
The socket must be suitable for the load indicated on the tag and must have ground contact connected and in operation. The earth conductor is yellow-green in colour. This operation should be carried out by a suitably qualified professional. ln case of incompatibility between the socket and the appliance plug, ask a qualified electrician to substitute the socket with another suitable type.
Page 6
• The appliance must not be installed behind a decorative door in order to avoid overheating. • When you place the shelf inside, make sure that the stop is di- rected upwards and in the back of the cavity. The shelf must be inserted completely into the cavity.
General Instructions We thank you for choosing one of our products. For the best results with your oven, you should read this manual carefully and retain it for future reference. Before installing the oven, take note of the serial number so that you can give it to customer service staff if any repairs are required. Having removed the oven from its packaging, check that it has not been damaged during trans- portation.
The grounding wire connected to the oven’s earth terminal must be connected to the earth ter- minal of the power supply. WARNING Before connecting the oven to the power supply, ask a qualified electrician to check the conti- nuity of the power supply’s earth terminal. The manufacturer accepts no responsibility for any accidents or other problems caused by failure to connect the oven to the earth terminal or by an earth connection that has defective continuity.
Product description 1. Control panel 2. Shelf positions (lateral wire grid if included) 3. Grids 4. Trays 5. Fan (if present) 6. Oven door 7. Lateral wire grids (if present: only for flat cavity) 8. Serial number ACCESSORIES Drip tray Metal grid Collects residues that drip when cooking food Holds baking trays and plates.
Display description 1. Thermostat selector knob 2. Cooking time 3. Function selector knob To set the cooking time, turn dial one complete revolution and then position the index to the required time. When the time has lapsed, the signal will ring for a few seconds.
Cooking Modes T °C T °C Symbol Function range fault LAMP: Turns on the oven light. * CONVENTIONAL: Both top and bottom heating elements are used. Preheat the oven for about ten minutes. This method is ideal for all tradi- 50 ÷...
General notes on cleaning The lifecycle of the appliance can be extended damp sponge. through regular cleaning. Wait for the oven to cool before carrying out manual cleaning op- ACCESSORIES erations. Never use abrasive detergents, steel Clean accessories with a wet, soapy sponge wool or sharp objects for cleaning, so as to not before rinsing and drying them: avoid using irreparably damage the enamelled parts.
Waste management and environmental protection This appliance is labelled in SAVING AND RESPECTING THE ENVIRON- accordance with European Di- MENT rective 2012/19/EU regarding Where possible, avoid pre-heating the oven electric and electronic appli- and always try to fill it. Open the oven door as ances (WEEE).
Page 14
Sommario Indicazioni di Sicurezza Avvertenze Generali Descrizione del Prodotto Descrizione del display Modalità di cottura Pulizia e manutenzione del forno Manutenzione Risoluzione dei Problemi Garanzie Installation IT 14...
Indicazioni di Sicurezza • Durante la cottura, l’umidità può condensarsi all’interno del vano cottura o sul vetro della porta. Questa è una condizione normale. Per ridurre questo effetto, attendere 10-15 minuti dopo l’accensione prima di mettere gli alimenti all’interno del forno.
Page 16
dell’elettrodomestico in sicurezza, comprendendo i rischi che derivano dall’uso dello stesso. • Le operazioni di pulizia e manutenzione non devono essere effettuate dai bambini senza sorveglianza. • Non utilizzare materiali ruvidi, abrasivi o raschietti metallici affilati per pulire le porte in vetro del forno, dato che possono graffiare la superficie e causare la frantumazione del vetro.
Page 17
La presa deve essere adatta al carico indicato sulla targhetta e deve avere il contatto di terra collegato e in funzione. Il conduttore di terra è giallo-verde. Questa operazione deve essere eseguita da un professionista adeguatamente qualificato. In caso di incompatibilità...
Page 18
• L’interruzione prolungata dell’alimentazione durante una fase di cottura potrebbe causare un guasto del monitor. In tal caso contattare il servizio clienti. • L’elettrodomestico non deve essere installato dietro a una porta a scopo ornamentale per evitarne il surriscaldamento. • Quando si posiziona uno scaffale all’interno, accertarsi che il blocco sia rivolto verso l’alto e nella parte posteriore della guida.
Avvertenze Generali Vi ringraziamo per aver scelto uno dei nostri prodotti. Per utilizzare il forno in modo ottimale è consigliabile leggere con attenzione questo manuale e conservarlo con cura per ogni ulteriore consultazione. Prima di installare il forno, prendere nota del numero di serie in modo da poterlo comunicare al personale del servizio di assistenza in caso di richiesta di intervento.
ATTENZIONE Prima di collegare il forno alla rete elettrica, far controllare la continuità della messa a terra della rete elettrica ad un elettricista qualificato. Il produttore declina ogni responsabilità per eventuali incidenti o altri problemi derivanti dal mancato collegamento a terra del forno o dal suo collega- mento ad una messa a terra con una continuità...
Descrizione del Prodotto 1. Pannello di controllo 2. Posizioni dei ripiani (griglia metallica laterale se inclusa) 3. Griglie 4. Vassoi 5. Ventola (se presente) 6. Sportello del forno 7. Griglie metalliche laterali (se presenti: solo per cavità piane) 8. Numero di serie ACCESSORI Vassoio di gocciolamento Griglia metallica...
Primo utilizzo PULIZIA PRELIMINARE Pulire sempre il forno prima di utilizzarlo per la prima volta. Pulire le superfici esterne con un panno mor- bido leggermente inumidito. Lavare tutti gli accessori e pulire l’interno del forno con del detergente per piatti ed acqua calda. Verificare che il forno sia vuoto, impostare la temperatura massima e lasciarlo acceso per almeno 1 ora, così...
Modalità di cottura Manopola T° Intervallo commu- preim- Funzione di T° tatore postata LAMPADA: accende la luce interna. * STATICO: sono in funzione le resistenze superiore e inferiore. È la cot- 50 ÷ MAX tura tradizionale, ottima per arrostire cosciotti, selvaggina, ideale per bis- cotti, mele al forno e per rendere i cibi molto croccanti.
Pulizia e manutenzione del forno La vita di servizio dell’apparecchio si allunga se Se sporca, la guarnizione può essere pulita con questo viene pulito ad intervalli regolari. Atten- una spugna leggermente inumidita. dere che il forno si raffreddi prima di effettuare le operazioni di pulizia manuali.
Gestione dei rifiuti e rispetto dell’ambiente Questo apparecchio è con- Quando si acquista un nuovo apparecchio, quel- trassegnato in conformità alla lo vecchio potrebbe essere restituito al rivendi- Direttiva europea 20 12/19/EU tore che deve acquisirlo gratuitamente su base sulle apparecchiature elettriche singola, sempre che l’apparecchio sia del tipo ed elettroniche (WEEE).
Installation 600 mm 595 mm 20 mm 590 mm 595 mm 20 mm INSTALLATION 26...
Page 27
EN If the furniture is coverage with a bottom at the back part, provide an opening for the power supply cable. EN If the oven does not have a cooling fan, create an opening 460 mm x 15 mm IT Se il mobile ha un fondo posteriore, praticare un foro per il passaggio del cavo di alimentazione.
Need help?
Do you have a question about the Idea FIDC X502IT 65 L A and is the answer not in the manual?
Questions and answers