Removing the Bezel-Label Strip
If you have received the HP J Class upgrade kit, you will need to remove the old
bezel-label strip from your workstation and replace it with the new one. Here is the brief
procedure for performing this task:
1. Remove your workstations bezel as shown the section "Front Bezel and Top Cover"
2. Remove the old bezel-label strip from the bezel. To do this, push up on the two
Figure 2-2
Removing the Bezel-Label Strip
To replace the bezel-label strip, perform the above steps in reverse.
Chapter 2
in this chapter.
bezel-label strip release tabs shown in the top diagram of Figure 2-2 and rotate the
bezel label strip away from the bezel as shown in the bottom diagram of Figure 2-2
Component Remove/Replacement
Component Removal and Replacement
15