Atech Flash Technology BLACKJET TX-2DS User Manual

Thunderbolt 3 dock

Advertisement

Quick Links

TX-2DS
Thunderbolt 3 Dock
USER GUIDE
Speci cations are subject to change without further notice.
All trademarks, trade names and copyrights are properties of their respective owners.
Thunderbolt and the Thunderbolt logo are trademarks of Intel Corporation in the U.S. and/or other
countries.
Atech Flash
Technology, Inc.
Atech Flash Technology
930 Auburn Court
Fremont, CA 94538
Tel: 510.824.6868
support@atechflash.com
www.atechflash.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the BLACKJET TX-2DS and is the answer not in the manual?

Questions and answers

Summary of Contents for Atech Flash Technology BLACKJET TX-2DS

  • Page 1 TX-2DS Thunderbolt 3 Dock USER GUIDE Atech Flash Technology 930 Auburn Court Atech Flash Fremont, CA 94538 Technology, Inc. Tel: 510.824.6868 Speci cations are subject to change without further notice. support@atechflash.com All trademarks, trade names and copyrights are properties of their respective owners.
  • Page 2: Important Safety Warnings

    Introduction Thank you for purchasing Blackjet TX-2DS Cinema Dock! Blackjet TX-2DS is a 2-Bay Docking Series system where you can design your own workflow solution. Blackjet TX-2DS boosts your video workflow by using two Thunderbolt™ 3 Connections with speeds of up to 40Gb/s.
  • Page 3: Inserting Modules

    Inserting Modules Inserting your DX Modules 1. Locate your DX module you wish to use. 2. Hold the DX module and gently insert it into the drive slot. 3. Push into the drive slot until you feel the DX module is secure. 4.
  • Page 4: Connecting To Computer

    Connecting TX-2DS Connecting to Computer 1. Plug in the Power Cord to TX-2DS power connector port. 2. Connect one end of Thunderbolt 3 cable to Thunderbolt 3 port on the TX-2DS. 3. Connect the other end of Thunderbolt 3 cable to Thunderbolt 3 port of computer.
  • Page 5: Removing Modules

    Removing Modules Important Notes! Please eject and remove any media card or cards before swapping out DX Modules. 1. Locate your DX module you wish to remove or swap out. 2. Grab hold of the DX module and gently pull until it is ejected from the drive slot.
  • Page 6: Safety Information

    Power Supply Blackjet TX-2DS utilizes a 12V adapter, please do not use a different power adapter to avoid corruption/damage to the product and data failure.
  • Page 7: Limited Warranty

    Limited Warranty Atech Flash Technology, Inc. ("AFT"), warrants to the original end user ("Customer") that under normal intended use AFT media docking solutions will be free from defects in materials and workmanship for two (2) years from the date of purchase. During warranty period, AFT shall either repair, or replace defective product.

Table of Contents