Related Manuals for Tunstall TM2
Summary of Contents for Tunstall TM2
- Page 1 Installation, Technical Specifications and Mounting English Doc. 346 80 21-46. Version 2. Revision 09.2020...
-
Page 2: Table Of Contents
1 Introduction ................................3 1.1 Safety ................................3 1.2 Compliance ............................... 3 1.3 EU Declaration of Conformity ........................... 4 2 TM2 components ..............................5 3 Functionality ................................7 3.1 Bluetooth ................................7 3.2 Tx75 and IDT ..............................7 4 Specifications ................................8 4.1 Electrical specifications ............................. -
Page 3: Introduction
The TM2 box does no have any physical user interface apart from a status LED. To configure the TM2 box, a dedi- cated configuration application from Tunstall is needed. This guide will only cover the functionality and installation requirements of the TM2 box, not the specifics about the configuration application. -
Page 4: Eu Declaration Of Conformity
1.3 EU Declaration of Conformity... -
Page 5: Tm2 Components
2 TM2 components The TM2 unit consists of the following components: Front: LED light for status (1) The colour and the display of the LED light indicates the status of the TM2 according to the following: Colour Light Status GREEN... - Page 6 Back: I/O ports terminal (2) I/O switch (3) Power supply terminal (4)
-
Page 7: Functionality
“open” commands to a connected Carelock ACE lock upon receiving a signal from a Tx75 transmitter or a pulse from its wired input connector. The TM2 box can also be used for transforming a Tx75 signal into a wired signal, for exam- ple to open an electric strike lock. -
Page 8: Specifications
4 Specifications 4.1 Electrical specifications TM2 is designed to be used in an installation with long cables attached. Power supply: 10 – 30 V DC, < 350 mA Output: Relay (COM, NO, NC) which can withstand 10 – 30 V DC, 1A Input: 10 –... -
Page 9: I/O Ports
350 mA. The power source must have a current limitation of maximum 5 A. If the TM2 unit is going to be used with a Carelock ACE Split lock, you may want to connect the TM2 box to a power source that will be cut off by the fire alarm. -
Page 10: Mounting
To make a simple mounting plate, use for example a metal or plastic plate that you drill five holes into. Attach the plate to the TM2 box with 7 mm wide screws made for plastic (1). Attatch the plate to the designated mounting sur-... -
Page 11: Technical Specifications
6 Technical Specifications Radio Frequency (Tx75 protocol) Operating Frequency 868.300 and 869.2125 MHz Maximum radio-frequency power transmitted +10.5 dBm EIRP Radio Frequency (Bluetooth Low Energy) Operating Frequency 2400 MHz to 2483.5 MHz Maximum radio-frequency power transmitted +4 dBm EIRP Electrical Supply voltage 10-30 V DC Maximum current drain... - Page 12 Tunstall does not accept responsibility for any errors and omissions within this document. © 2020 Tunstall Group Ltd. ® Tunstall is a registered trademark. Tunstall declare that this radio equipment is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following address: www.tunstall.se/privacy/certifieringar...
Need help?
Do you have a question about the TM2 and is the answer not in the manual?
Questions and answers