Table of Contents
Advertisement
11. install the push handle into the table, as
shown in figure 30, with a 12mm flat washer
and M12-1.75 t-nut.
12mm Flat Washer
push
handle
figure 30. sliding table push handle installed.
12. thread two M6-1 x 12 set screws into the
small holes in the small extension table.
Make sure the set screws do not stick out
from the mating surface.
13. loosely attach the small extension table with
two M10-1.5 x 20 cap screws, two 10mm
lock washers, and two 10mm flat washers as
shown in figure 31. note: The cap screws
will be tightened during a later step.
figure 31. small extension table attached.
14. loosely attach the large extension table with
four M10-1.5 x 20 cap screws, four 10mm
lock washers, and four 10mm flat wash-
ers, as shown in figure 32. note: The cap
screws will be tightened during a later step.
g0493 14" sliding table saw
M12-1.75 t-nut
figure 32. large extension table attached.
15. attach the support brace and dust collection
hose support to the table with five M10-1.5 x
30 cap screws and five 10mm lock washers,
as shown in figure 33.
dust Collection
hose support
support Brace
figure 33. support brace and dust collection
hose support installation.
16. use a straightedge, as shown in figure 34,
to make sure the extension table is even with
the cast iron table. use the set screws under
the extension tables to level the top surfaces,
then tighten all the mounting cap screws.
figure 34. Checking with a straightedge.
-25-
Advertisement
Table of Contents
