Grizzly G0493 Owner's Manual page 26

7.
secure the sliding table to the cabinet with
three M12-1.75 hex nuts, three 12mm lock
washers, and three 12mm flat washers.
note: Use the access holes on each side of
the cabinet to reach the T-bolts on the ends
of the sliding table (figures 25 & 26). To
access the T-bolt in the center of the sliding
table, tilt the blade to 0° and reach through
the dust port (figure 27).
figure 25. left end access hole.
figure 26. right end access hole.
figure 27. dust port access hole to access
center t-bolt.
-24-
8. install the lock plate as shown in figure 28
using four of the screws removed in step 1.
figure 28. installing the lock plate.
9. install the end handle, as shown in figure
29, using the remaining screws removed in
step 1.
figure 29. sliding table end handle.
10. rotate the table lock 180˚ to unlock the slid-
ing table. the sliding table is locked in place
when the table lock is in the position shown
in figure 29.
g0493 14" sliding table saw
lock plate
table lock
end handle