Related Manuals for dlb AIJGO-61BT
Summary of Contents for dlb AIJGO-61BT
- Page 1 +36-20-386-7572 AIJGO-61 / AIJGO-61BT RESISTANCE METERS USAGE GUIDE www.dlb.hu sales@destsa.hu +36 27 502 555...
-
Page 2: Table Of Contents
TABLE OF CONTENTS Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 The product and accessories supplied with it . -
Page 3: Overview
Overview The AIJGO-61 / AIJGO-61BT resistance meter resistance meter can be used to measure the resistance of different materials, work surfaces and floors. The measured result can be viewed on an OLED display after the measurement. CE declaration We declare that the AIJGO-61 and the AIJGO-61BT product complies with the requirements of IEC 61340-5-1, ANSI/ESD S20.20 and Directive 2001/95/EC (General... -
Page 4: About Construction And Use
Mode button (2) With long keypress (3 sec.) you can store the measured values in the case of AIJGO-61, if you use AIJGO-61BT, you can switch on and off the automatic measurement mode with this action. Measure button (5) For the AIJGO-61, hold the button to perform a measurement. -
Page 5: User Instructions And Information
User instructions and information Connecting accessories Connect the instrument, cables, electrodes and, if necessary, grounding according to the measurement method to be used. Measurement methods Point-to-point measurement (Rp-p) Connect the BNC plug ends of the wires to the instrument and the black shielding wire connectors to the black sockets of the electrodes and the red measuring wire connectors to the red sockets of the electrodes. -
Page 6: Turning On
Measuring voltage Measurement The AIJGO-61 and the AIJGO-61BT is suitable for measuring a wide resistance range, between 2 Ω and 1 TΩ. This also enables the measurement of equipment grounding resistance and the resistance of ESD protective worksurfaces to ground. Thus there is no need to use other resistance meter during ESD qualification or compliance verification measurements. -
Page 7: Storing Measurement Results
When using the AIJGO-61BT, if the automatic measurement mode is enabled, press the “Measure” button once to start a 5-second measurement. For a measurement of a different duration, hold the button for the desired amount of time, regardless of whether the automatic measurement mode is enabled or not. - Page 8 Handling measurement results in the ESD Wise system in case of the AIJGO-61BT The measured data from the AIJGO-61BT product can be received via Bluetooth on an Android smart device using the ESD Wise Android smart device application. This app can then wirelessly transmit the data to the ESD Wise management software.
-
Page 9: Maintenance
Maintenance Replacement of the batteries If the batteries are discharged, a screenshot similar to the following will be displayed: 31.6 kΩ LOW BATTERY 24.5°C 42.1%RH In this case the measuring instrument is automatically set to 10 V measuring voltage. You can remove the cover plate by unscrewing two screws on the back of the meter to change the batteries. - Page 10 D és Tsa Bt . 2600 Vác, Dr. Csányi László Krt. 83. Hungary Tel . / Fax: +36 27 502 555 +36 27 200 835 E-mail: sales@destsa.hu Web: www.destsa.hu www.dlb.hu AIJGO products support: aijgoservice@destsa.hu +36-20-386-7572...
Need help?
Do you have a question about the AIJGO-61BT and is the answer not in the manual?
Questions and answers